Front indicators/side replacements
Discussion
I know there has been several threads though after a couple of bored afternoons on ebay I managed to purchase 2 front clear indicators (about £20) and clear side indicators (about £5).
So I set about yesterday morning to fit them; I hope the added pics help.
I put it on ramps just to make it easier to work on and its always good to have a quick look underneath.
Well as per the advice on here, I cut out as much silkaflex/sealant as I could from the front using a Stanley knife. The drives side was alot easier to work on through the grills than the offside due to the air intake pipe taking up quite alot of room!
Some gentle persuasion popped them out (when I mean gentle quite alot of force was used)
When they were out a quick clean up change the bulbs over a good dollop of no more nails attached round the new lights, pushed it back into place let it set enough to keep it in place then sealed the front with clear silicone sealant. (very handy when there is two people there to hold things in place)
The side lights were pretty straight forward, though my new clear ones didn't come with clips so I just cleaned up the area and used number plate adhesive pads to attached them to the wing.
All in a all a quick modernising mod that doesn't take too much time / knowledge.
Some pics of the car as well for good measure..
Oh and whilst I had the lights out I wondered what it would look like if you added fog lights / extra lights in the grill I didn't think it looked too bad?







A quick touch up round the edges is where I am off to right now..
So I set about yesterday morning to fit them; I hope the added pics help.
I put it on ramps just to make it easier to work on and its always good to have a quick look underneath.
Well as per the advice on here, I cut out as much silkaflex/sealant as I could from the front using a Stanley knife. The drives side was alot easier to work on through the grills than the offside due to the air intake pipe taking up quite alot of room!
Some gentle persuasion popped them out (when I mean gentle quite alot of force was used)
When they were out a quick clean up change the bulbs over a good dollop of no more nails attached round the new lights, pushed it back into place let it set enough to keep it in place then sealed the front with clear silicone sealant. (very handy when there is two people there to hold things in place)
The side lights were pretty straight forward, though my new clear ones didn't come with clips so I just cleaned up the area and used number plate adhesive pads to attached them to the wing.
All in a all a quick modernising mod that doesn't take too much time / knowledge.
Some pics of the car as well for good measure..
Oh and whilst I had the lights out I wondered what it would look like if you added fog lights / extra lights in the grill I didn't think it looked too bad?







A quick touch up round the edges is where I am off to right now..
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


