Manifold Gasket
Manifold Gasket
Author
Discussion

blueg33

Original Poster:

47,025 posts

255 months

Monday 4th May 2009
quotequote all
I have an exhaust manifold gasket leaking (ticking noise and definately from the manifold) Its only one. My car is not a chim or a griff but does have RV8 engine. I have tubular headers.

Is it possible to replace a manifold gasket just by slackening off the manifold bolts or do I need to take the whole manifold off? The latter means that I will have to undo a flange which has proved to be troublesome to re-seal. It is now sealed so I am reluctant to undo it if I dont have too.

I was planning on using a composite gasket and figured i could cut a couple of slots to drop it over the bolts/studs.

Also, what torque do I need to do the bolts up too?

Cheers

Nick

gog

286 posts

285 months

Monday 4th May 2009
quotequote all
I find that if you just remove the bolts completely, from the affected port, you can then slide out the old gasket and slide in a new with ease!
Torque is 16lbf ft or 22nm.
Hope this is of some help, good luck.

blueg33

Original Poster:

47,025 posts

255 months

Sunday 10th May 2009
quotequote all
Is the torque right? seems a bit low?

Also do I need to use a gasket sealing compound? I have composite gaskets?

Cheers

GreenV8S

31,027 posts

315 months

Sunday 10th May 2009
quotequote all
They're small bolts into aluminium - don't overdo them. It's only a matter of time before the threads strip, and the tighter you do them up the sooner that will happen. Second the suggestion to take the bolts right out and drop the gasket in. There are various types of gasket, the best ones I've found are the embossed metal composite ones sold by Clever Trevor. I also suggest you get yourself a set of K-head ARP manifold bolts (Real Steel). These give far more space to get a spanner on, and most of them can then be got at with a ratchet ring spanner which makes the job a heck of a lot easier.

blueg33

Original Poster:

47,025 posts

255 months

Sunday 10th May 2009
quotequote all
Thanks. I have those gaskets, space is a pain, but i think i have donthe job so far. Tightented a little more than 16ftlbs but not by much

No leaks so far!

Mick