Injectors not opening
Injectors not opening
Author
Discussion

Chimjunkie

Original Poster:

2,879 posts

242 months

Saturday 9th May 2009
quotequote all
Since i have the top of the engine in bits to replace all the rocker gear and followers i thought i would connect up the inlet manifold with the injector rail in tact on a bench. Connected the fuel lines up to the car, fuel pressure read 3 BAR. only 5 out of the 8 injectors opened when tickled with 4v! 3v didn't open any. When the pressure dropped to almost nothing the other 3 injectors opened. I know i have been down on power recently but 3 out of 8!? I'm sure if i put more voltage accross them they would open when under pressure, but thought the ECU only delivered 3volt? (over 3A available from battery pack according to volt meter. And the resistances of the injectors read consistently)

Because there was such marked difference in their ability to open, i will be buying another complete set.

I guess max fuel pressure only occurs under full throttle?

lotusandy

257 posts

302 months

Saturday 9th May 2009
quotequote all
I think the injectors get 12v, if so it is not suprising that they don't all open at 3volts!
I would not rush to get new ones before you know they are broken for sure. Have you measured thier individual resistances?

Andy

Mark Adams

358 posts

291 months

Saturday 9th May 2009
quotequote all
The standard injectors are high impedance (14 Ohms), and will only open properly if you connect them straight to 12 Volt battery. However they are very sensitive to battery voltage (which is why the ECU has to compensate opening times), and I'm amazed that any of them opened at all.

Be sure there are no sparks near opened injectors though if you want to keep your eyebrows! yikes

Chimjunkie

Original Poster:

2,879 posts

242 months

Saturday 9th May 2009
quotequote all
Thanks for the enlightening comments folks! Dont know where i got the 3v thing from? Sure i read that somewhere on here... Will check all again.

Mark! Please book me in for a tune up smile We spoke a while ago, but my engine broke a timing chain when you had a slot to fit me in.

Seasider

12,728 posts

280 months

Saturday 9th May 2009
quotequote all
Chimjunkie said:
I know i have been down on power recently....
Pathetic excuse wink

Chimjunkie

Original Poster:

2,879 posts

242 months

Sunday 10th May 2009
quotequote all
Seasider said:
Chimjunkie said:
I know i have been down on power recently....
Pathetic excuse wink
The girlfriend is quicker in her lotus in a straight line eek Thats my trick! frown


lewis_sharman

5,958 posts

222 months

Sunday 10th May 2009
quotequote all
Chimjunkie said:
Seasider said:
Chimjunkie said:
I know i have been down on power recently....
Pathetic excuse wink
The girlfriend is quicker in her lotus in a straight line eek Thats my trick! frown
How much power is the lotus making?

Sorry just curious nerd

Seasider

12,728 posts

280 months

Sunday 10th May 2009
quotequote all
Chimjunkie said:
Seasider said:
Chimjunkie said:
I know i have been down on power recently....
Pathetic excuse wink
The girlfriend is quicker in her lotus in a straight line eek Thats my trick! frown
Might be all those bolt on bits wink

Chimjunkie

Original Poster:

2,879 posts

242 months

Sunday 10th May 2009
quotequote all
lewis_sharman said:
How much power is the lotus making?

Sorry just curious nerd
235bhp @ fly. 960kg car.

My car has felt noticeably slower for a little while now. Hestitates on acceleration occasionally too. Will look at the air flow and throttle pot sensors soon. Need to get it back to Mr Adams for a tune up. meant to do this after the timing chain change.

Going to singe my eyebrows later this morning and retest the injectors. All done safely of course. No sparks...

Chimjunkie

Original Poster:

2,879 posts

242 months

Sunday 10th May 2009
quotequote all
lotusandy said:
I think the injectors get 12v, if so it is not suprising that they don't all open at 3volts!
Andy
Just searched for the thread where i thought GreenV8S mentioned 3v. He clearly stated 12v!! Oh boy, I think i need to see a nurse... Now if 5 of the 8 had not functioned perfectly at 4v then i would have realised the error!!

hehe


Mark Adams

358 posts

291 months

Sunday 10th May 2009
quotequote all
Chimjunkie said:
Mark! Please book me in for a tune up smile We spoke a while ago, but my engine broke a timing chain when you had a slot to fit me in.
It would be a pleasure! Just give me a call tomorrow - I'm doing a racer at TVR Power this week if that's any use?

You were so unlucky to bust a timing chain - I've never come across this particular nasty before!

Chimjunkie

Original Poster:

2,879 posts

242 months

Sunday 10th May 2009
quotequote all
Mark Adams said:
It would be a pleasure! Just give me a call tomorrow - I'm doing a racer at TVR Power this week if that's any use?

You were so unlucky to bust a timing chain - I've never come across this particular nasty before!
Hi Mark. Timing chain broke due to bolt coming out of oil pump housing getting caught in chain. This sheared a tooth off the cam pulley and snapped chain. Am replacing rocker gear and cam followers at moment to sort out a tappy top end. Should be able to get engine back together in a few days. All injectors worked fine with 9v today. Coventry fine for me. Will give you a call.

Jon.

Ant.

5,254 posts

312 months

Monday 11th May 2009
quotequote all
Mark Adams said:
Chimjunkie said:
Mark! Please book me in for a tune up smile We spoke a while ago, but my engine broke a timing chain when you had a slot to fit me in.
It would be a pleasure! Just give me a call tomorrow - I'm doing a racer at TVR Power this week if that's any use?

You were so unlucky to bust a timing chain - I've never come across this particular nasty before!
At power next week too Mark?