Oilel Pressure and Wheel Rims
Discussion
Good afternoon.
I have just been to see a 450 Chimaera and have noticed a couple of details that I would like clarifying.
Firstly, oil presure seemed to be a bit low at cold start-up at around 35-40 psi. Is this right or is it low ?
Secondly when looking at the exterior of the car I noticed that there seemed to be flat spots on both wheel rims on the near-side. I wondered if this may have been a casting fault but it did cross my mind that it could be something more sinister. Can anyone advise.
The rest of the car seemed to be in very good condition.
Cheers.
I have just been to see a 450 Chimaera and have noticed a couple of details that I would like clarifying.
Firstly, oil presure seemed to be a bit low at cold start-up at around 35-40 psi. Is this right or is it low ?
Secondly when looking at the exterior of the car I noticed that there seemed to be flat spots on both wheel rims on the near-side. I wondered if this may have been a casting fault but it did cross my mind that it could be something more sinister. Can anyone advise.
The rest of the car seemed to be in very good condition.
Cheers.
GreenV8S said:
King Fisher said:
oil presure seemed to be a bit low at cold start-up at around 35-40 psi. Is this right or is it low ?
Oil pressure will vary with revs and temperature and will also depend on the oil grade, but 35-40 psi is fine - you'll see a lot lower than that at hot idle.
seems normal.Ok, many thanks for the replies on that, you've put my mind at rest. My only other worry is the rims. They looked in perfect order, with no scratches or scuffs, but both rims on the passenger side had flat spots on them. Is this a real cause for alarm, or is it some form of casting fault that some TVR rims had?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


