oil question
oil question
Author
Discussion

project 112

Original Poster:

83 posts

213 months

Monday 11th May 2009
quotequote all
i changed the oil presure sender unit on the 400 engine i,am going to be using in a replica, the engine has,nt run for about 3 years! although it has oil in and has been turned over at regular intervals on the key. a small amount of oil leaked out when i removed the old sender, does this mean i will need to prime the pump again before i eventually start the engine if so how do i do this? also do i have to fill a new oil filter with oil before i fit it? any help would be much appreciated thanks

schmokin1

1,223 posts

243 months

Monday 11th May 2009
quotequote all
i was a bit paranoid about starting my pre serp 400 for the first time after a 2 year layup. I primed the pump by blowing oil back up the filter feed with a washing up liquid bottle. The filter was part full but i lost a fair bit getting it back on. Mine was fine so I wouldn't worry TOO much, just be prepared to kill the engine if the light/gauge doesn't respond as expected after a few seconds of running.

Good luck!

project 112

Original Poster:

83 posts

213 months

Monday 11th May 2009
quotequote all
thanks for that, hoping to start it in a couple of weeks as soon as i,ve got my fuel lines sorted out. fingers and everything else crossed! lol