Vibration under load
Discussion
Hi all, can anybody help me what could be the cause of the vibration when accelerating around 2000 rpm? The whole interior resonates which ruins the overall good feeling of the car... The car had a major rebuild during winter: camshaft, tappets, rocker shaft, fingers, conrod and big end bearings, clutch, pre cats removed, ignition parts, exhaust gaskets, engine mounts. I had this vibration since the first start after the layup. Any ideas?
Cheers,
Wal
Cheers,
Wal
Blast - I thought I had the answer until you said you'd replaced the engine mounts...
If they've sagged or torn the manifold can rest on, or just vibrate against, a chassis rail at certain revs, and that was my initial thought.
Probably still worth checking the clearance between the underside of the manifolds and the chassis just to be sure?
Giles
If they've sagged or torn the manifold can rest on, or just vibrate against, a chassis rail at certain revs, and that was my initial thought.
Probably still worth checking the clearance between the underside of the manifolds and the chassis just to be sure?
Giles
Edited by Clippy on Thursday 14th May 11:46
Walkie,
Is it only RPM related? Just a thought, but you mentioned it happens under acceleration, if it only happens when the car is moving and is evident under acceleration more than related to a fixed RPM I would look at the prop shaft UV joints.
The joints could well have started to seize during the lay up and give a vibration, but this would be more road speed and acceleration related not RPM. Many people find that the annual recommended application of grease is often missed during service. You probably need to drop the exhaust to get at the grease nipple.
Purple V8
Is it only RPM related? Just a thought, but you mentioned it happens under acceleration, if it only happens when the car is moving and is evident under acceleration more than related to a fixed RPM I would look at the prop shaft UV joints.
The joints could well have started to seize during the lay up and give a vibration, but this would be more road speed and acceleration related not RPM. Many people find that the annual recommended application of grease is often missed during service. You probably need to drop the exhaust to get at the grease nipple.
Purple V8
Chimjunkie said:
I'm thinking exhaust touching chassis too.
fitting new engine mounts is not just a matter of slapping them in,the engine can be adjusted height wise left to right(cradle fashion)if they are just chucked in and tightened up there is a good chance that one manifold runs close/touches the chassis while the other does not,its easier to centralize the mass with everything loose then nip the bolts up,i have done three sets of these and have found this to be the case on different Chims,and yes they both had the spacer on just one mounting,this is not a knock of the O/P just a heads up really Gassing Station | Chimaera | Top of Page | What's New | My Stuff



