Just bought a Chim 450! Low oil pressure though :-(
Just bought a Chim 450! Low oil pressure though :-(
Author
Discussion

ferark

Original Poster:

128 posts

225 months

Saturday 16th May 2009
quotequote all
Hi Guys, wanted a Chimaera for ages. Just sold my Defender 4.6 V8 and as we are supposed to be in for a cracking summer (don't blame me if we don't) I thought I'd take the plunge.

Seems a good car, clean enough, sounds as sweet as a nut with a chassis that is in good nick. possible problem though, the oil pressure when warm is only 20lbs, is this a bit too low as I've heard it should be 25-30lbs.

just wondered if it could be: Oil to thin (I think it should be 15/50?), gauge is out, pump is almost dead, oil pick-up blocked?

Is it a big job to do an oil pump?

Cheers in advance.

Clippy

196 posts

214 months

Sunday 17th May 2009
quotequote all
Depends in whether that's at tickover or whilst driving...

Warm you should get somewhere between 10-20 psi at tickover (many get around 15), and under load/at revs you should see 30+

Giles

ferark

Original Poster:

128 posts

225 months

Sunday 17th May 2009
quotequote all
Hi Clippy, cheers for the reply.

The gauge reads 20 when warm, sounds like it's ok. Phew!

I'm guessing reading through a few posts on this forum that they differ quite a lot from car to car, inaccurate gauges on TVR's?

teamrecon

154 posts

220 months

Sunday 17th May 2009
quotequote all
On my 450, I get around 15 at idle, not sure under load though, I'm concentrating on the road too much !!wobble

Zippee

14,159 posts

265 months

Sunday 17th May 2009
quotequote all
10-15 on warm idle and circa 30 under load when warm are about right. The 15/50 is also perfect for the RV8 which needs the thicker oils.

debaron

878 posts

228 months

Sunday 17th May 2009
quotequote all


I have similar readings on my 400 Serp.
You can do a quick check if you can get under the car.

Remove the wire from the oil pressure sender and earth it against the engine somewhere. Take a look at the gauge and it should be all the way over to the right.

This shows the gauge isn't defective. You can then change the Oil Pressure sender (There are various threads on here with where to buy and part numbers etc - depends on which gauges you have - Black or White).

If you're still getting low oil pressure then just live with it! These V8's run on high volume not high pressure. You would want to worry if the Oil Pressure light on the Speedo ever comes on though. That is run from a separate sender and goes on at something like below 7 psi.


HTH


Ryan

hoach

49 posts

218 months

Sunday 17th May 2009
quotequote all
Don't worry about the low oil pressure, I remember the days of adjusting the idle of an engine so that the oil light, or the charging light for the generator is just out! 50 to 70 rpm could make all the difference. I'm gettin' old!


Get it on LPG!

dhf

1,103 posts

225 months

Sunday 17th May 2009
quotequote all
if you are worried,take it to a garage and get them to check the oil pressure you have,it will relieve any worries you have.

Edited by dhf on Sunday 17th May 22:49

quattrophenia

1,103 posts

229 months

Sunday 17th May 2009
quotequote all
Just out of interest ferark, are there any similar characteristics of the RV8 4.6 you have noticed between your old Range Rover and The Tiv?

Blown2CV

31,662 posts

234 months

Sunday 17th May 2009
quotequote all
reading is fine, i get 15psi on 10w40 mineral and hope to increase this with 15w50 mobil1 fully synth at next change

ferark

Original Poster:

128 posts

225 months

Sunday 17th May 2009
quotequote all
quattrophenia said:
Just out of interest ferark, are there any similar characteristics of the RV8 4.6 you have noticed between your old Range Rover and The Tiv?
The Defender 4.6 was an auto on LPG so no real similarities, they were both very smooth all the way through the rev range, but the weight difference is 1080kg to 2350kg so no.

Has anyone put LPG on a Chimaera yet? Would be quite interesting to see, my Defender ran quicker on LPG than petrol as it's much higher octane, people seem to have the impression it's the other way around.

PS Cheers for all the replies!

GJOSDDLO

92 posts

211 months

Sunday 17th May 2009
quotequote all
I experienced the same thing. I found that using thicker oil solves the problem.

Oil pressre sit's at 15 when idle & engine is warm.

good luck.



Edited by GJOSDDLO on Sunday 17th May 22:32

Benjaminpalma

1,214 posts

213 months

Monday 18th May 2009
quotequote all
ferark said:
quattrophenia said:
Just out of interest ferark, are there any similar characteristics of the RV8 4.6 you have noticed between your old Range Rover and The Tiv?
The Defender 4.6 was an auto on LPG so no real similarities, they were both very smooth all the way through the rev range, but the weight difference is 1080kg to 2350kg so no.

Has anyone put LPG on a Chimaera yet? Would be quite interesting to see, my Defender ran quicker on LPG than petrol as it's much higher octane, people seem to have the impression it's the other way around.

PS Cheers for all the replies!
I'd be fascinated to hear the answer to this. In fact, I'm going to start a new thread. Replies on there, please!

nawarne

3,181 posts

291 months

Monday 18th May 2009
quotequote all
Just be aware that the guages can often read low - - in true TVR fashion!!

My old V8S was similar to above (pre-serp engine obviously) and when it was at Power they checked it versus a calibrated instrument and it was reading 8/10 psi low.

Nick.

nawarne

3,181 posts

291 months

Monday 18th May 2009
quotequote all
Just be aware that the guages can often read low - - in true TVR fashion!!

My old V8S was similar to above (pre-serp engine obviously) and when it was at Power they checked it versus a calibrated instrument and it was reading 8/10 psi low.

Nick.

nawarne

3,181 posts

291 months

Monday 18th May 2009
quotequote all
Just be aware that the guages can often read low - - in true TVR fashion!!

My old V8S was similar to above (pre-serp engine obviously) and when it was at Power they checked it versus a calibrated instrument and it was reading 8/10 psi low.

Nick.