Chim 4l cold start problems
Chim 4l cold start problems
Author
Discussion

whenman

Original Poster:

3 posts

222 months

Sunday 17th May 2009
quotequote all
I'm getting a little more than annoyed with this one. I have a good spark, fuel and good healthy turn over, why won't she fire.

I've done the usual; check connectors, I definately have fuel, the fuel pump runs, all the sensors/systems check out as per the bible, rotor arm looks good, leads look good yet the big finger is being given.

This happened over night(literally) I had a few running problems, so cleaned the stepper motor which seemed to give the result I wanted. went out to day and it most definatly wasn't having it.

Any help greatly appreciated

Cider Andy

1,889 posts

256 months

Monday 18th May 2009
quotequote all
Where's the spark? If the rotor arm's failed you'll get one from the coil but not at each plug.

How did you check for fuel? If the plugs are wet it may be just flooded (it's very easy to flood these engines).

Konrod

912 posts

259 months

Monday 18th May 2009
quotequote all
Are you sure you've got fuel - the pump may be coming on but are the injectors firing. Check the silver relays on top of the battery.

J

Karussell

157 posts

275 months

Monday 18th May 2009
quotequote all
Check you have a spark from the coil at the end of the king lead, before it gets to the dizzy.

I had a cutting out problem that resulted in no/intermittent spark from the coil

Changed the ignition module and coil, and problem solved. Worth checking as a pretty cheap fix also

K

whenman

Original Poster:

3 posts

222 months

Monday 18th May 2009
quotequote all
Thanks for the input guys.

I'm getting a spark at the plugs (I checked 2 just to be on the safe side!) I know I'm getting fuel as I've removed all the plugs to check and give them a clean and sort out after it wouldn't start the first time and they were wet again the next. They are all relatively new plugs (a month old?), rotor arm looks good, dizzy cap looks good etc. any other suggestions?

blitzracing

6,422 posts

251 months

Tuesday 19th May 2009
quotequote all
Take the plugs out and leave the combustion chambers open for a while to let any excess fuel evaporate before you put them back. Then fill the plenum with Easy Start (remove one of the blanking plugs to get access then replace it afterwards) and give it a go. If it still wont fire, its going to be ignition. A spark in free air is not the same as under compression and with fuel trying to put it out. The ECU has a funny trick, where the first few seconds of cranking it just dumps fuel in, ignoring any input from the AFM. Once its running it then monitors the AFM input the get the fueling nearer correct. If you have a bad air leak, the engine will catch for a few seconds then die at the point the AFM reading is used.