Discussion
hi
how do i go about getting the correct firing order on my serp 4.0 the dizzy has never been removed or turned since the engine was last run and cam/crank timing has not been changed,so in theory its just a question of puting the right lead on the right plug. do i turn the engine until no1 piston is at tdc and then match this up with the pin that the rotor is pointing to in the dizzy then simply work my way round the dizzy in the correct order ie 1 8 4 3 6 5 7 2 if so is it a anti clockwise or a clockwise direction? while i,am here what leads would you recomend?
how do i go about getting the correct firing order on my serp 4.0 the dizzy has never been removed or turned since the engine was last run and cam/crank timing has not been changed,so in theory its just a question of puting the right lead on the right plug. do i turn the engine until no1 piston is at tdc and then match this up with the pin that the rotor is pointing to in the dizzy then simply work my way round the dizzy in the correct order ie 1 8 4 3 6 5 7 2 if so is it a anti clockwise or a clockwise direction? while i,am here what leads would you recomend?
Yes clockwise, make sure TDC is on compression by sticking your finger in the plug hole to feel the pressure.
Joo ex TCS made up leads with some nice cable, and has just started selling on ebay, so they may be a bit of a bargain... give me a shout if you can't find them (jootvr IIRC).
Joo ex TCS made up leads with some nice cable, and has just started selling on ebay, so they may be a bit of a bargain... give me a shout if you can't find them (jootvr IIRC).
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


