Car will not fire up
Discussion
I have a Chim 4.6.
I parked it up and all was fine. Went out to it a few days later and although the engine turns over it will not start.
I checked the plugs and they are dry after several attempts, so I looked at the fuel relays and decided to replace them as one was a bit corroded.
I can hear the fuel pump priming and there is petrol in the fuel injector rail.
The alarm, if it was still armed, would not allow it to turn over so I reckon that is OK.
Loads of Petrol in the tank.
I even tried the fuel cut off switch in the passenger footwell.
Any suggestions, other than join the RAC for a home start, which I reckon I will end up doing!
I parked it up and all was fine. Went out to it a few days later and although the engine turns over it will not start.
I checked the plugs and they are dry after several attempts, so I looked at the fuel relays and decided to replace them as one was a bit corroded.
I can hear the fuel pump priming and there is petrol in the fuel injector rail.
The alarm, if it was still armed, would not allow it to turn over so I reckon that is OK.
Loads of Petrol in the tank.
I even tried the fuel cut off switch in the passenger footwell.
Any suggestions, other than join the RAC for a home start, which I reckon I will end up doing!
Sound like the ECU is not powered up/dead and therefore not firing the injectors. Worth sticking a scope on the injectoirs to see if there is any pulsees from the ecu. Could be the immobilser not powering up the ECU (seperate circuit to everything else). Could be bad connection on the ECU plug.
Steve
www.tvrbooks.co.uk
Steve
www.tvrbooks.co.uk
Had a similar problem lately. It turned out that the engine was flooded. Take the sparks out and let the starter run in order to get rid of the fuel in the engine. After that let the sparks dry. Maybe this helps! Remember, plug out every other thing who could overheat because of that.
Have a nice weekend!
Have a nice weekend!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




