Intermittent battery light
Intermittent battery light
Author
Discussion

MrShifty

Original Poster:

249 posts

201 months

Thursday 5th August 2010
quotequote all
The battery warning light on my d/d Chim started coming on last week. It was only happening when starting from cold and there was a slight chirp so I put it down to the fanbelt slipping slightly. Engine temperature was normal and everything was turning happily under the bonnet so I added 'tighten the fan belt' to my todo list.

However, this morning I went out in it and the light came on, flickering off intermittently (as the fanbelt slipped I thought) but then stayed on constantly for about 7 miles when I drove home later.

I had a look under the bonnet whilst the engine was on and couldn't see/hear it slipping. I guess my alternator might be dying - is there an easy way for me to check? Or might it just be a loose connection/slipping fanbelt?

Stevie Mojo

1,520 posts

268 months

Thursday 5th August 2010
quotequote all
Sounds like the alternator to me too.

Any garage will be able to test to see if it's charging properly.

If it is knackered they're easy to swap.

BeastMaster

443 posts

218 months

Friday 6th August 2010
quotequote all
Just put a meter across the battery - Should have around 13.5 / 14volts engine running and around 12volts no engine. Bought mine from a motor factor £65 exchange, now realise that it was getting tired because the battery has more power to crank the engine when starting - Andy

MrShifty

Original Poster:

249 posts

201 months

Saturday 7th August 2010
quotequote all
Thanks for the replies everyone. I have a few jobs to do on the car today so will be looking at this one this afternoon.

BeastMaster said:
Just put a meter across the battery - Should have around 13.5 / 14volts engine running and around 12volts no engine. Bought mine from a motor factor £65 exchange, now realise that it was getting tired because the battery has more power to crank the engine when starting - Andy
To rule out connection issues/anything else, is it possible/easy to measure across the alternator in isolation when the engine is on?

Reconditioned alternators seem to be about a quarter of the cost of new ones. Are they genuinely good value or would I be better paying full whack for a new one?