Going to have another dabble at me 430,bit of info. please
Going to have another dabble at me 430,bit of info. please
Author
Discussion

kenny.R400

Original Poster:

1,212 posts

271 months

Friday 13th August 2010
quotequote all
Guys, haven't posted for a while on the tech side since selling the 400 and being involved with another none Tiv project, but next week i've got access to a 4 post ramp so want to get the 430 up on it for a pre MOT check and fettle. It's been stuck in a mates barn for 6 weeks!!!

So, I did a lot to the car when I bought it a couple of monthes ago and everything works apart from the speedo.........I had a few attempts to fix it but gave up on itredface

Symptoms were it would work perfect then stop, then come back on etc. etc........it finally stopped altogether. I'm going to have another bash and hopefully sort it now

Previous owner had new g/box sender fitted at TvR so I'm assuming all is ok with it.

So the questions.......it's a 93 car BTW.

1) There are 2 wires to sensor from dash, what colour should they be (my wires are so grubby so you can't tell)

2) Is one a live and one a pulse?

3) Previous owner mentioned something about TvRoad fitting something to wiring (Capacitor he said) which "fell off/got burned" at the time I thought no more about it.................but having just struggled to get an electric speedo to "talk" to my transducer on current project I finally cracked it by fitting a 2.2k resistor to "jump" the pulse wire up from the live after being advised this was the fix.

Is there a possibility that the TVR needs this too and that was what TvRoad fitted? As I say I'd love to get this sorted.

Many thanks for any tips or advice.

Cheers,
Kenny

PS if anythings buggered with the castle thing on the back axle it can stay buggered and I'll use a GPSsmile

P400PLS

404 posts

258 months

Friday 13th August 2010
quotequote all
Kenny,

My speedo recently stopped working and whilst mine is a 98 400 I'll describe the repair process.

Firstly the failure was speedo, mileometer and trip counter.

Initial thoughts were the sensor on the differential, apparently there are two different types, both were tried both no success. The original sensor was araldited into the mounting bracket, so the bracket had to be replaced as well.

After further investigation by the guys at Neil Garner the next suspect device was some electronics in the circuit mounted behind the dash. They managed to track down one of these black boxes and that did the trick and the speedo came back to life. ( Thanks Pete )

I have no idea about the colour of the various wires but I hope this helps.

spend

12,581 posts

282 months

Friday 13th August 2010
quotequote all
Not at all the 93 is chalk & cheese.

It was all explained to OP in a previous post IIRC, can't think anything was missed?

kenny.R400

Original Poster:

1,212 posts

271 months

Friday 13th August 2010
quotequote all
I had a few cryptic hints and a bit of coded black magic in reply to my previous post but no straight answer from anyone who'd sorted the problem smile.......doesn't matter it will be sorted this week.

Thanks for the input anyway.

Edited by kenny.R400 on Friday 13th August 21:51

loud430

550 posts

214 months

Friday 13th August 2010
quotequote all
mine turned out to be a faulty sensor on a bracket on top of the diff.

spend

12,581 posts

282 months

Saturday 14th August 2010
quotequote all
Maybe it was discussed in another post then? it came up recently for a 430 anyway...

430 has sensor above nose of the diff, wires tend to be siliconed into the sensor then about 12" to a connector under the trans tunnel (tied to upper chassis rail), whence they enter the cabin at the back of the tunnel cover and run under the trans tunnel direct to the speedo (no black box no ecu connection).

As I said before bad connections near the sensor are likely (and fact that TvR replaced it may be significant?). You can only do continuity tests to the speedo if you remove the dash top and get at the sensor (prob strip out sealant and reseal after..) which might mean dropping exhaust &/or prop??. I can only recall working on it while I had diff out - but made sure it was all sorted whilst I had access. As mentioned before ETB speedo itself seems pretty reliable (apart from ticking wink ) can't recall of any problems reported TBH.