Routing of extra wires.
Routing of extra wires.
Author
Discussion

Pink_Floyd

Original Poster:

900 posts

252 months

Saturday 14th August 2010
quotequote all
I am going to be adding a widband lambda sensor and a pickup for megasquirt. What is the best way to route the cables from front of engine back into the cabin.? Via passenger wheel arch.?

Simon says

19,466 posts

252 months

Saturday 14th August 2010
quotequote all
I went in through the wiper motor loom bung(very accomodating)with the coil pack wires and the WB wiring & vacuum hose,the trigger wires kept separate and they go into the inner wing.

spend

12,581 posts

282 months

Saturday 14th August 2010
quotequote all
If you haven't done anything to prevent water running down the inner wing that is a likely water trap.

I wouldn't use it from past experience of problems (even trying to solve with nearly 2 tubes of sikaflex!) even though I now divert the water down the wings which you should do at least IMHO.

SILICONE KID

14,997 posts

262 months

Saturday 14th August 2010
quotequote all
What i don`t understand is why does the water from the window screen drop on to the engine .Im surprised some one as not modified the bit of metal with the holes in it to direct on to the inner wings .

Simon says

19,466 posts

252 months

Sunday 15th August 2010
quotequote all
spend said:
If you haven't done anything to prevent water running down the inner wing that is a likely water trap.

I wouldn't use it from past experience of problems (even trying to solve with nearly 2 tubes of sikaflex!) even though I now divert the water down the wings which you should do at least IMHO.
I have got to try though as it's a nice entry point Spend,did read sometime you mentioning this point but thought you may be referring to the main engine loom grommet behind the heater hoses confused i did intend to divert the water from the heat shield/lower inner wing area at some point anyway as i def don't want water coming in at this point especially as my car as been water tight for sometime although it don't get wet much anyways apart from washing rolleyes that would also be one of the worst are'a to take in water seeing as it's location is close to the fusebox frown

2Munkys

1,228 posts

268 months

Monday 16th August 2010
quotequote all
This is my WB routing; it's in a Griff and follows the induction hose path where it is shielded from the heat of the manifolds to some extent. Off the top of my head, I'm not sure how this differs in a Chim so may not be of much use to you.