Spring compressor ?
Spring compressor ?
Author
Discussion

Naybr

Original Poster:

209 posts

197 months

Friday 20th August 2010
quotequote all
Does anyone know where I can get a compressor small enough for a Chim rear springs?

My old Sykes ones have hooks which are too big to get between the coils so I bought a new set from Screwfix. A different design, but again the hooks are too big. Grrr.


Naybr

Original Poster:

209 posts

197 months

Friday 20th August 2010
quotequote all
Sorry if this is a stupid question, but do you NEED to compress these units before removing them from the car ...?

Th spring looks under compression, but maybe it is at the full extent of it's travel as limited by the shock? They are the original non-adjustable ones by the way.

FlipFlopGriff

7,144 posts

278 months

Friday 20th August 2010
quotequote all
If you jack up using the main chassis rail (below the diff) and let the suspension drop you'll be able to get the spring out. You're likely to have more problem shifting the nut/bolt as they are probably seized. You may need to jack the suspension up a bit to ease the bolt out.
Put copperslip on when you replace them and replace the bolt/nut/washer. Don't gorget its a nyloc nut.
FFG

spend

12,581 posts

282 months

Friday 20th August 2010
quotequote all
Crack both nuts with the tension of damper (every little bit of grip on the bolt head helps wink ) then take the top bolt out first so you can tap it out and release the tension before starting on the awkward lower front..

Remember to put a jack under the upright for support otherwise it will fall on you when you remove the first bolt (damper is at full stretch in tension holding the corner up on droop).

peaktorque

1,807 posts

242 months

Friday 20th August 2010
quotequote all
Two rachet straps always work for me smile