startup misfire
Discussion
Recently my chim has been living outside, 100% NO lakage into the cabin so im fairly happy with that.
on startup on wet mornings, she misfires like a B***H, for about 30 seconds than it all evens out and shes happy.
obviously there is water getting on something, but what could cause this?
im not too happy with my stepper motor either bus this isnt the cause....
suggestions on a post card...!
on startup on wet mornings, she misfires like a B***H, for about 30 seconds than it all evens out and shes happy.
obviously there is water getting on something, but what could cause this?
im not too happy with my stepper motor either bus this isnt the cause....
suggestions on a post card...!
Yes, the distributor cap in particular may have a hairline crack in it that's invisible to the naked eye.
Moisture from condensation under the cap or carbon dust will find its way into the crack and create a track.
As the engine heat rises the moisture will be forced out of the crack and the misfire will subside.
I have to say a lot of other things like worn out plug leads & or plug extenders could also be the problem.
However I would still start with the cap & rotor arm as these are really service consumable parts that should be replaced every 10,000 miles or so.
Just make sure you use a genuine old stock Lucas rotor arm and a decent brand of cap.
Moisture from condensation under the cap or carbon dust will find its way into the crack and create a track.
As the engine heat rises the moisture will be forced out of the crack and the misfire will subside.
I have to say a lot of other things like worn out plug leads & or plug extenders could also be the problem.
However I would still start with the cap & rotor arm as these are really service consumable parts that should be replaced every 10,000 miles or so.
Just make sure you use a genuine old stock Lucas rotor arm and a decent brand of cap.
Had the exact same issue for ages - in the end a replacement stepper motor cured it instantly. Basically if the stepper motor is poor then it will not open up as it should on start up and hence will not let enough air in. This results in very rich mixture that fouls the plugs, and to make this worse the ecu sees unburn fuel as 'weak' mixture and puts more fuel in!!!
You mention that your stepper is not right so almost certainly this is where your problem lies. Sort this before replacing anything else.
You mention that your stepper is not right so almost certainly this is where your problem lies. Sort this before replacing anything else.
Edited by JKY on Friday 27th August 11:16
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


