Not starting Chim 400
Not starting Chim 400
Author
Discussion

ButtonIt

Original Poster:

385 posts

209 months

Friday 27th August 2010
quotequote all
My Chim 400 is a bit buggered at the moment. It was working fine a couple of weeks ago, but whilst driving for the weekend she started messing around.

When I try to start her nothing happens. I'll run through the scenario:

Unlock doors with key fob (disarms immobiliser)
Check little red light on steering column is off and not flashing
Turn ignition on
Dashboard comes to life
Fuel pump primes
Turn to START

and then all I have is a little click from the passenger footwell. I've done the "lights on" check (from another thread), to see if they dim, no difference. I've given the underside of the dash a good thump to see if it's the immobiliser contacts (from another thread) and no difference. I've stuck jump leads on it, just in case it was a lack of battery power, nothing.

I do vaguely recall a slight electrical burning smell when stopped at some traffic lights, but dismissed it as it wasn't strong and I was next to a lorry (which can make all kinds of smells).

The car is now in my front garden waiting to go up on ramps (I'll need someone to help me bump start it so I can drive the bugger on first though).

Any ideas? I've read on here a lot about sticky starter solenoids etc, could it be that the mechanism hasn't come back down the shaft and stayed in contact with the ring gear? Therefore burning out the contacts/wiring? Just a dead starter?

All advice appreciated smile

Barkychoc

7,848 posts

235 months

Friday 27th August 2010
quotequote all
Try giving the starter a good old fashioned wallop with a lump of wood - if the solenoid is stuck you may find it frees it.
You'll probably have to do it from underneath the car, so please apply some common sense so the car doesn't drop on your nut.

Colin RedGriff

2,541 posts

288 months

Saturday 28th August 2010
quotequote all
ButtonIt said:
Any ideas? I've read on here a lot about sticky starter solenoids etc, could it be that the mechanism hasn't come back down the shaft and stayed in contact with the ring gear? Therefore burning out the contacts/wiring? Just a dead starter?

All advice appreciated smile
If you're hearing a click then the starter solenoid is being switched, so don't think it's the immobiliser. Certainly sounds like a starter motor problem either sticking or possibly failed.

They do suffer in the TVR with a lot of heat and they can breakdown. Straightforward enough to replace if you can get under the car. There are improved versions out there from various suppliers. Definitely worth doing the David Beer hot start mod while you are working on the car for longer term reliability.

Barkychoc

7,848 posts

235 months

Saturday 28th August 2010
quotequote all
Op says click is coming from passenger footwell which I presumed was the relay to energise the solenoid?

Colin RedGriff

2,541 posts

288 months

Saturday 28th August 2010
quotequote all
Missed that read

ButtonIt

Original Poster:

385 posts

209 months

Tuesday 31st August 2010
quotequote all
So, first stage is to whack it, ok biggrin I'll see if I can get the bugger started (bump) and up on the ramps. I'll get the multimeter out too, see if I can detec voltage at the starter.

ButtonIt

Original Poster:

385 posts

209 months

Wednesday 1st September 2010
quotequote all
Just out of interest, is the starter the same as the Range Rover? I can get that for £140, whereas RG want nearly three hundred...

lesstatt

4,318 posts

221 months

Wednesday 1st September 2010
quotequote all
exactly the same as a RR, i got one from TVR car parts for arud £120 last year because apparantly TVR neds a higher torque motor but im not convinced, Land Rover V8 ones are aroud £60 so if it goes again i will stick in one of those