boot latch wont catch
boot latch wont catch
Author
Discussion

spice

Original Poster:

654 posts

301 months

Monday 30th August 2010
quotequote all
fiddled for ages buy cant get the latch to catch fully down, you can just pull the bootlid back up again , very annoying anyone else had this ?

Pink_Floyd

900 posts

252 months

Monday 30th August 2010
quotequote all
Have you tried putting a screw driver against the catch to check that it will latch. If its not latching then no amount of adjustment to the striker is going to help.

Alexdaredevilz

5,697 posts

210 months

Monday 30th August 2010
quotequote all
Make sure the latch hasn't latched, press the button and it might click,
Or it might be latched and abit sticky so put a screw driver in the hole and lift up and get some one to press the button

Alex

scotty_d

6,795 posts

225 months

Monday 30th August 2010
quotequote all
My boot solenoid burned out a couple of months ago as i had left the boot open all of winter when in the barn , it stuck in the fully open position holding the catch in the release position so i could not close it when it went back on the road , i rigged up a old bike cable to get me by until i picked up a new one from maplin for 12 quid. worth a look if to see if the solenoid is holding the little section of cable over.

Scotty

spice

Original Poster:

654 posts

301 months

Monday 30th August 2010
quotequote all
i took the bolt off and it makes the catch ok , the release button fires ok and the catch opens , just cant seem to get the angle or length correct to make the catch when the bolt is fitted to the bootlid , it fires with a distint bang when made correctly and a small whine sound when not , when its not fully made you can pull the lid up or it gets stuck and its the light out job to pull the release, only a small thing but driving me nuts.