Temp gauge
Temp gauge
Author
Discussion

minkybob

Original Poster:

341 posts

202 months

Friday 3rd September 2010
quotequote all
Hi
Temp gauge dicky for a day or two now given up.
Looks like sensor behind dizzy but not sure.
What does everyone think might be wrong.

1999 450

Cheers need some help


minkybob

Original Poster:

341 posts

202 months

Friday 3rd September 2010
quotequote all
HELP!

fat tony

392 posts

238 months

Friday 3rd September 2010
quotequote all
Take the top dash off and check all the leads are connected to the gauge. The black one came off mine and made it read 120+!. Are the fans coming on? If they are, then otter switch is working.

minkybob

Original Poster:

341 posts

202 months

Friday 3rd September 2010
quotequote all
Fans are working fine and car runs fine

WOO5IE

968 posts

228 months

Friday 3rd September 2010
quotequote all
take the wire off the sender and connect it to earth an dsee if you get the gauge to move.

Will prove whether its the sender or not

fat tony

392 posts

238 months

Friday 3rd September 2010
quotequote all
Found mine could also be held at a set temp if i put the heater fans on, bizarre. if the fans are working then otter is ok. As mentioned it could be the temp sender.

minkybob

Original Poster:

341 posts

202 months

Saturday 4th September 2010
quotequote all
Were do I get a temp sender?

Cheers

Naybr

209 posts

197 months

Saturday 4th September 2010
quotequote all
The senders rarely go wrong (although the whole set-up isn't especially accurate) if earthing the cable gives a full scale reading on the gauge then you might try removing the sender and its adapter and just giving it a good clean.

The sender is in a sort of cooling 'blind alley' and is only in contact with the cooling water via a narrow passageway. On mine this was blocked up with crud.

It's probably just possible to do this without disturbing the distributor - a rachet spanner would help.

On teh other hand, if you are going to drain off a couple of litres of coolant, you might decide to replace it on spec. The usual parts suppliers stock them and they aren't especially expensive bits.


David Beer

3,982 posts

298 months

Saturday 4th September 2010
quotequote all


Edited by David Beer on Sunday 5th September 18:45

David Beer

3,982 posts

298 months

Sunday 5th September 2010
quotequote all
David Beer said:
They go all the time, use the spare sender on top of the head, a180ohm resistor will be about right, as we all know it's only a gauge a Of course if you want posh, use a 200 ohm variable to get the same reading as you had before