Bonnet hinge pins
Discussion
I've done this sucessfully on both sides. There is actually a brass bobbin which is supposed to be embedded in the GRP.
I repaired it by cutting out a 'teardrop' shape in alloy (I made a cardboard pattern first) bonding the bobbin to it and then the whole thing to the bonnet. I actually pop rivetted it too - but in my case the hole had enlarged quite a lot...
I then did a 'belt and braces' job by using a hole cutter to cut through the stiffening section behind the hinge and glassing it in from the other side. I filled the hole with a grommet afterwards and painted the alloy black.
It all looks and works fine.
I repaired it by cutting out a 'teardrop' shape in alloy (I made a cardboard pattern first) bonding the bobbin to it and then the whole thing to the bonnet. I actually pop rivetted it too - but in my case the hole had enlarged quite a lot...
I then did a 'belt and braces' job by using a hole cutter to cut through the stiffening section behind the hinge and glassing it in from the other side. I filled the hole with a grommet afterwards and painted the alloy black.
It all looks and works fine.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


