Location of Heater Fan/Blower???
Discussion
Hi,
I am trying to find the exact location of my heater fan that blows warm or cold air into the cabin area. The reason for this, is that the bearing in the fan it-self needs replacing as it is very loud!! on setting 3.
I need to take the fan unit out and strip it down and replace the bearing or obtain a new fan unit.
I have heard from a previous thread that the fan could only be removed by cutting a hole in the inner wing and removing the fan unit and then, repairing the hole.
Not what i would like to do really.
Anyone replaced theirs??
Cheers
Dale
I am trying to find the exact location of my heater fan that blows warm or cold air into the cabin area. The reason for this, is that the bearing in the fan it-self needs replacing as it is very loud!! on setting 3.
I need to take the fan unit out and strip it down and replace the bearing or obtain a new fan unit.
I have heard from a previous thread that the fan could only be removed by cutting a hole in the inner wing and removing the fan unit and then, repairing the hole.
Not what i would like to do really.
Anyone replaced theirs??
Cheers
Dale
I had to do this the other day.
1. Remove carpets in passenger footwell
2. Remove panel in front of battery/fuse box
3. Remove battery
4. Unbolt fuse box and move to one side
5. Remove battery box (three bolts accessed from passenger wheelarch)
6. Pull back carpet covering inner wing.
7. Locate fan wire connector block and dissconnect.
8. Fan should be located behind a fibreglass panel secured by rivets and sikaflex.
9. Drill rivets (replace with self tapping screws)
10. Cut Sikaflex with sharp knife and prise back panel.
11. You should now see the fan in all its glory.
If you can get the fan out you're doing better than I did. I managed to fix mine in situ.
Not wishing to dampen your enthusiasm but it's a right pain in the a*se
Good luck
Ed
1. Remove carpets in passenger footwell
2. Remove panel in front of battery/fuse box
3. Remove battery
4. Unbolt fuse box and move to one side
5. Remove battery box (three bolts accessed from passenger wheelarch)
6. Pull back carpet covering inner wing.
7. Locate fan wire connector block and dissconnect.
8. Fan should be located behind a fibreglass panel secured by rivets and sikaflex.
9. Drill rivets (replace with self tapping screws)
10. Cut Sikaflex with sharp knife and prise back panel.
11. You should now see the fan in all its glory.
If you can get the fan out you're doing better than I did. I managed to fix mine in situ.
Not wishing to dampen your enthusiasm but it's a right pain in the a*se
Good luck
Ed
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


