V8S Clean sheet
Discussion
Hi all,
Been posting on the S series section but opinions re V8 engines are talk to you boys.
Right I am stripping a 91 S V8 completely for a full nut & bolt rebuild, not looking for massive power, just a hotter cam and port/match the heads a little, but where do I start with a new management system, what do you rate? it's 3.9 pre-cat. After the best reliable system.
Cheers
Ray
Been posting on the S series section but opinions re V8 engines are talk to you boys.
Right I am stripping a 91 S V8 completely for a full nut & bolt rebuild, not looking for massive power, just a hotter cam and port/match the heads a little, but where do I start with a new management system, what do you rate? it's 3.9 pre-cat. After the best reliable system.
Cheers
Ray
Here's one they made earlier
http://www.lloydspecialistdevelopments.co.uk/Fully...
hope that gives you an idea
Mark
http://www.lloydspecialistdevelopments.co.uk/Fully...
hope that gives you an idea
Mark
To be honest the 14CUX is fine in non catalyst mode on near standard engines, its just the distributor and ignition thats falls short of the mark. There are significant gains to be made with mapped ignition and the fuel consumption under light engine loads. The 14CUX gets bad press on catalyst engines as it tries to hold the mixture leaner than really suits the RV8 at low speed that can lead to some snatching.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


