Going to try it myself
Going to try it myself
Author
Discussion

Kwacker

Original Poster:

641 posts

315 months

Wednesday 8th September 2010
quotequote all
I have an exhaust gasket that is blowing, so I am going try and replace them myself.

I am aware that it is possible to shear/snap bolts which will require them to be tapped and drilled. So I am going to prep with lots of wd-40/penetrating oil.

What else should I be careful of? Has anyone else done this? What can I expect other than grazed knuckles?

I really hope I don't bugger it up and have the car off the road for any longer than necessary.

Kwacker

Chuggaboom

1,152 posts

279 months

Wednesday 8th September 2010
quotequote all
I was advised to use the metal faced version of the gaskets.

Seal off the ports with duck tape before drilling out if it becomes needed....yes I know they exhausts but might as well nullify the risk altogether.

Even if one or two shear off, shouldn't stop use of the car if just held on by 2....just a PITA if have to take the manifold(s) off again to finish the job.

Edited by Chuggaboom on Wednesday 8th September 16:23

Alexdaredevilz

5,697 posts

210 months

Wednesday 8th September 2010
quotequote all
If your doing the passengers side its quicker to take the cat back off so you can get to the underside of the manifold

walt762

240 posts

263 months

Wednesday 8th September 2010
quotequote all
I agree with above use metal faced gaskes and drop the exhaust for easy access to the lower bolts on the near side also replace the bolts with ARP bolts with smaller heads which makes it easier to fit a spanner to, get them from ACT Performance Products.

Colin RedGriff

2,541 posts

288 months

Thursday 9th September 2010
quotequote all
Don't rush and don't try to force the bolts. Release them gradually and avoid snatching at the bolts. Smooth application of pressure on the spanner will minimize shearing of the bolts.

A selection of spanners helps, stubbys and half moons. Once they were loose I found I could get a half moon ratchet on some of them which helped getting the bolts completely out.

A couple of the bolts can't be fully removed until the manifold is pulled back from the head.

A couple of them are reachable from the wheel arch with socket and extensions (1/4" drive)

It's a lot easier to reach the rear offside bolt from below with the starter motor out of the way. Drop the exhause for the nearside bolts.

Change the bolts for the Nordlok ones

When replacing the manifolds it was easier to line up the manifolds with the y-piece removed

winters

217 posts

222 months

Friday 10th September 2010
quotequote all
As said, smaller headed replacement bolts make life much easier, and a small touch of grease on the way back in.

Easier to loosely rejoin manifolds to Y piece before the manifold bolts are fully tightened, apparently, otherwise can be a struggle smile

Flintstone

8,644 posts

278 months

Friday 10th September 2010
quotequote all
winters said:
...a small touch of grease on the way back in.
As a matter of interest which type of grease should or shouldn't be used in such a high temperature application?

daveparry

988 posts

231 months

Friday 10th September 2010
quotequote all
Any copper based anti sieze grease is fine!