Rear lower wishbone cracked - replacement Q's
Rear lower wishbone cracked - replacement Q's
Author
Discussion

domV8

Original Poster:

1,409 posts

212 months

Wednesday 8th September 2010
quotequote all
Hey guys,

I have a crack in the rear drivers-side lower wishbone (I think thats right?) - the "brace" (in the apex of the tubing) where the droplink is bolted through...

I don't have a picture, but the flat "brace" is snapped 4/5s the way through - with only a tiny portion holding the brace together. The crack is right next to the droplink-hole, but does not actually pass right through it...

I have just upgraded the droplinks to Steve Heath rose-jointed one's, so I guess the extra force on the wishbone must have exploited a weakness in the brace and cracked it....

My questions are:

1. Should I replace the entire lower wishbone rather than repair it..?
2. Is replacing it a relatively simple operation - or is there more to it than one would think?
3. Will the car need to be re-geo'ed after the wishbone is replaced, or should the geometry be preserved?

Any info much appreciated,


Dom

slideways

4,101 posts

252 months

Wednesday 8th September 2010
quotequote all
I had one of mine fail bought a mk2 replacement from adrian@ member on here got someone to weld it in the same place then painted it no geo required.
just to be clear thats the droplink mount not the whole wishbone

Edited by slideways on Wednesday 8th September 23:19

Colin RedGriff

2,541 posts

288 months

chimaera1855

334 posts

199 months

Thursday 9th September 2010
quotequote all
how was ur car after the Steve Heath rose-jointed???thinking of getting that soon

Simon says

19,466 posts

252 months

Thursday 9th September 2010
quotequote all
slideways said:
I had one of mine fail bought a mk2 replacement from adrian@ member on here got someone to weld it in the same place then painted it no geo required.
just to be clear thats the droplink mount not the whole wishbone

Edited by slideways on Wednesday 8th September 23:19
If its the same part that broke as Slideways i would go his route no question wink

Sparky99

87 posts

201 months

Thursday 9th September 2010
quotequote all
Mine cracked recently and all I did was:

Remove the drop link
Weld up the crack
Place a metal plate underneath the bar
Put the drop link back in.

domV8

Original Poster:

1,409 posts

212 months

Thursday 9th September 2010
quotequote all
Colin RedGriff said:
Thanks - winging its way to me now..!
Figure welding a new one in is probably better than welding the old one up... wink

Why are these braces so thin..? Surely something thicker is required, with all the force of the ARB pushing on it..?


Dom

JR

14,332 posts

289 months

Thursday 9th September 2010
quotequote all
domV8 said:
Why are these braces so thin..?
So that if you have an accident the A frames will distort instead of your chassis.

domV8

Original Poster:

1,409 posts

212 months

Thursday 9th September 2010
quotequote all
Ah - clever!