rear suspension / geometry adjustment.
rear suspension / geometry adjustment.
Author
Discussion

darkcat

Original Poster:

2,354 posts

201 months

Friday 10th September 2010
quotequote all
Well after my little "incident" this monday, i now have a new wheel fitted.
Looking at it, the bottom of the wheel is as it should be, just about level with the body line, (as per the other side) however the top is a good 15mm too far out. ~

Obviously im going to get the geometry done properly, but i want to adjust it to be about right for now, as i cant get it to the garage for a week or so.

So the question is - how do i adjust the rear camber? the adjustment is for the top wishbone.

Engineer1

10,486 posts

240 months

Friday 10th September 2010
quotequote all
I'd head to your local chain mechanics get it on their ramp with a story about how it doesn't see right and see if they can tweak it, otherwise an "under teh arches" type might be able to tweak it for a few quid in a short time. Unless you are confident of what damage you did I wouldn't just stick a wheel on and pray.

darkcat

Original Poster:

2,354 posts

201 months

Friday 10th September 2010
quotequote all
Engineer1 said:
I'd head to your local chain mechanics get it on their ramp with a story about how it doesn't see right and see if they can tweak it, otherwise an "under teh arches" type might be able to tweak it for a few quid in a short time. Unless you are confident of what damage you did I wouldn't just stick a wheel on and pray.
Thats just it, im waiting on the garage to get me in, i just want to tweek it so that its close for now.
I have had a VERY good look around under the arch and underneath, there appears to be no obvious damage.

Edited by darkcat on Friday 10th September 16:20

darkcat

Original Poster:

2,354 posts

201 months

Friday 10th September 2010
quotequote all
now THAT's how to answer a question!!!

nice one :-D

haircutmike

22,511 posts

235 months

Friday 10th September 2010
quotequote all
Peter.

If you have a garage with a level floor you can place a spirit level across the rim in a vertical position to see how far the camber is out.

What you need is, (from memory), about 1/2 degree neg camber.

Adjust the rear hub carrier at the wishbone, (elongated hole) as the film clip to give a tad of neg camber untill you get it profesionally set up.

Course if it is set up correctly and the wheel position looks wrong, start worrying eek

P.

spend

12,581 posts

282 months

Friday 10th September 2010
quotequote all
It'll be fine to just set the camber by eye to take and have it set up properly. Make sure the rear toe adjusters are freed, that seems to be a frequent problem and is the most unpleasant feeling crabbing along wink