In out in out in out....
In out in out in out....
Author
Discussion

loadblower

Original Poster:

793 posts

266 months

Friday 10th September 2010
quotequote all
That'll be my fuel pump!

Hi all...Posted some months ago, as I have been enduring a mind blowing cut out problem that has been going on for over a year now (maybe two..). As a result, I have a brand new coil, immobiliser and now a fuel pump (oh, new relays too!). Also had loom wiring checked and repaired

Yesterday, car cut out again for absolutely no reason whilst traveling at low speeds. Wouldn't restart. removed key, reprimed fuel pump, turned over but no firing (fuel light off). Tried again, this time pump wouldn't prime...then half primed...then kept turning itself on and off on its own accord!

Fortunately I was near home, so I left the car and returned later. Tried a restart, this time pump primed and it fired but was a bit rough. I had to keep some throttle down to stop it stalling, but after a three or four minutes was able to let it idle. Got it home in the end.

This is totally bizarre, almost ridiculous. The garage are out of ideas, as am I (not being en expert myself).

I can only think about the ECU now. This fault has been intermittent now for over a year, I could go for two months without it happening yet it is thoroughly preventing any enjoyment of the car I love. Depressing!

If anyone can solve this, there is a crate of beer in it. beer

Cheers!
RB

Pupp

13,043 posts

303 months

Friday 10th September 2010
quotequote all
Roll over inertia switch on the fritz? Behind the drop down panel where the handbook is supposed to go....

lotusandy

257 posts

302 months

Friday 10th September 2010
quotequote all
Poor earth connection on the fuel pump?

Andy

Number 7

4,113 posts

293 months

Friday 10th September 2010
quotequote all
You say that you've had the wiring checked. I had a similar problem some years ago which turned out to be fraying wiring to one of the fuel pump / inj system relays, just at the point it entered the back of the relay holder, so not normally visible.

7.

loadblower

Original Poster:

793 posts

266 months

Saturday 11th September 2010
quotequote all
Thanks all.

I'll speak with the garage about those points, and let you know.

Roll over inertia switch is something that hasn't been discussed...all of these need investigating further.

Much appreciated.

Russ

haircutmike

22,511 posts

235 months

Saturday 11th September 2010
quotequote all
I had a similar problem, for no reason just cut out anytime, without warning.

I replaced everything, even tried a different ECU, this went on for about a year.

In desperation I took it to Austecs in Crawley and they found a short behind the fuse board!

With a couple of other electrical things sorted, it cost £300.00, money well spent.

Moral of the story, take it to people that know TVR's, I wasted a lot of time searching.

Good luck

loadblower

Original Poster:

793 posts

266 months

Sunday 3rd October 2010
quotequote all
All,

Just a follow up to complete the circle. Followed Mike's advice and span the car over to Austec who identified that the ECU itself was faulty. Something to do with a dodgy transistor dropping the fuel pump relay in and out at random. Took them one week to find a problem that has been ongoing for two years in an otherwise very sound car. Worth bearing this problem in mind for cut outs of this nature.

No disrespect to my usual garage, but sometimes you need a fresh set of eyes/ideas....

Happy days!

Thanks for everyones help.

haircutmike

22,511 posts

235 months

Sunday 3rd October 2010
quotequote all
Austecs aren't cheap but they certainly know their business thumbup

loadblower

Original Poster:

793 posts

266 months

Sunday 3rd October 2010
quotequote all
Certainly thats been my experience! Now I have confidence in my car again which is certainly worth the money... cool

Clippy

196 posts

214 months

Sunday 3rd October 2010
quotequote all
Is this happening in the dry or only when it's wet?

Mine had a similar problem of cutting out but only when it got wet underneath - water was running up the power feed to the pump and causing a short due to cracked insulation on the wire...

Giles

loadblower

Original Poster:

793 posts

266 months

Monday 4th October 2010
quotequote all
Clippy,

No, seemed to be happen whatever the weather. Once happened at speed down the A30 into Devon on a hot dry June day...that was interesting...