Cermachrome / Exhaist coatings
Discussion
Iwas just going to get some of the cermachrome from Demon Tweeks, spray it and pack it off to my local matey with an oven. Wasn't too fussed, I thought the RV8 didnt respond particulalry well to exhaust mods so the drive for it was just to keep bay temps in check a bit.
Did anyone actually notice any difference whatsoever?
Did anyone actually notice any difference whatsoever?
Done properly the difference is quite amazing...
AFIK cermachrome is just a 'finish' the real coatings underneath & inside are satin black. Preparation is key, you need a fine ally oxide blast, blow off and do NOT touch (handle with sterile gloves). Then you need a very fine spray coat thin as possible just flowing yet no more, allow to air cure and then stick in the oven. Sounds simple but full of pitfalls
AFIK cermachrome is just a 'finish' the real coatings underneath & inside are satin black. Preparation is key, you need a fine ally oxide blast, blow off and do NOT touch (handle with sterile gloves). Then you need a very fine spray coat thin as possible just flowing yet no more, allow to air cure and then stick in the oven. Sounds simple but full of pitfalls

I had the manifolds and Y-piece on my Chim ceramic coated and the under bonnet temperatures improved dramatically.
IIRC, ACT Products do an exchange service where they will supply you with refurbished manifolds (i had the pre-cats removed also) for you to have blasted and ceramic coated then fitted. Once the old manifolds and Y-piece come off to fit the new ones, you send your old ones to ACT.
This was really handy as it meant the car wasn't off the road longer than necessary and it means you have refurbished manifolds, there's no point in forking out to have them ceramic coated if they're not going to last long anyway.
I can't remember the name of the company who did the ceramic coating but I'm sure ACT will be able to advise.
HTH
IIRC, ACT Products do an exchange service where they will supply you with refurbished manifolds (i had the pre-cats removed also) for you to have blasted and ceramic coated then fitted. Once the old manifolds and Y-piece come off to fit the new ones, you send your old ones to ACT.
This was really handy as it meant the car wasn't off the road longer than necessary and it means you have refurbished manifolds, there's no point in forking out to have them ceramic coated if they're not going to last long anyway.
I can't remember the name of the company who did the ceramic coating but I'm sure ACT will be able to advise.
HTH
Quinny said:
macdeb said:
Had mine done and they looked great, for a while. Now not looking so good at all after only about 6k miles. Gone dull and patchy. Anyone else with this?
Dude.... You probably just polished the finnish into oblivion

My manifolds have gone a bit "flat" but its been over 5 years now, and I'm pretty sure they're still keeping the radiant heat in check


Gassing Station | Chimaera | Top of Page | What's New | My Stuff




