Patch of oil under the clutch pedal
Discussion
On closer inspection at the top of the clutch rod, there is a very slight weeping of fluid from the seal. I also checked the checked the clutch reservoir and the fluid level looked ok.
Thanks for the info Kevin. I decided to go ahead and order the seal kit.
Can anybody please point me in the direction of any instructions on how to fit the seal ?
Thanks
Paul
Take the cyliner out first (or leave in if you're sure you can do it in situ) I reckon you probably could do it without removing, but it's a bit awkward to get at from the footwell.
If you can get under the car, drain as much fluid as you can from the bleed niple on the slave cylinder. If you can't get to it, you'll have to mop out as much fluid as you can from the top of the reservoir.
You need to unclip the pedal arm from the rod/actuator. This is just one clip that swings down, then the pin comes out and you will be free to get at the assembly.
You need to pull off the rubber boot (which you can see from the footwell),then there's a circlip holding the gubins in. Remove that and the piston should pull straight out. Have some rags underneath to catch the fluid! Once you have the piston out you can remove the fork from the end, and start disassembling as required.
The seal kit comes with about 7 or so separate seals. Just identify each one and replace like for like with what you have. (The big one is for the lid on the reservoir).
If you can get under the car, drain as much fluid as you can from the bleed niple on the slave cylinder. If you can't get to it, you'll have to mop out as much fluid as you can from the top of the reservoir.
You need to unclip the pedal arm from the rod/actuator. This is just one clip that swings down, then the pin comes out and you will be free to get at the assembly.
You need to pull off the rubber boot (which you can see from the footwell),then there's a circlip holding the gubins in. Remove that and the piston should pull straight out. Have some rags underneath to catch the fluid! Once you have the piston out you can remove the fork from the end, and start disassembling as required.
The seal kit comes with about 7 or so separate seals. Just identify each one and replace like for like with what you have. (The big one is for the lid on the reservoir).
Don't forget that brake fluid is excellent paint stripper so make sure you keep it well away from any paintwork and throw the rags you use to wipe things straight into the bin.
If you get any on your clothes make sure you don't then wipe it on the bodywork.
IF you do get any on paintwork then wash it off with copious amounts of water as quickly as possible.
If you get any on your clothes make sure you don't then wipe it on the bodywork.
IF you do get any on paintwork then wash it off with copious amounts of water as quickly as possible.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




have done 3 now like this and none have failed 