random cutting out...
random cutting out...
Author
Discussion

dog man

Original Poster:

552 posts

233 months

Monday 20th September 2010
quotequote all
I had a small glitch twice yesterday where the car cut out dead whilst going along then a second later (I'm still coasting at this point) I drop the clutch and we were off as if nothing was up.. then on the m1 in slow 50mph traffic it did it again but the next moment it came back on and fine all the way home and fine on the way to work this morn.

Haven't looked in the bible yet but fuel pump maybe? Coil? I seem to remember talk of a relay...one with a red line drawn on it, the car has a spare one but I can't remember what its for (doh)

Any help appreciated!

jr6yam

1,363 posts

214 months

Monday 20th September 2010
quotequote all
Did the rev counter also die when it happened?
If so it could be the igntion amp or Distributor pick up

John

dog man

Original Poster:

552 posts

233 months

Monday 20th September 2010
quotequote all
Hmmm, didn't notice, darn! Are those items easy enough to do? Ign amp I'm guessing lives in steering column cowling?

athomp04

177 posts

199 months

Monday 20th September 2010
quotequote all
I would suggest cleaning the stepper motor as well, as this could be the cause of the problem and even if not it is probably due a clean anyway.

jr6yam

1,363 posts

214 months

Monday 20th September 2010
quotequote all
dog man said:
Hmmm, didn't notice, darn! Are those items easy enough to do? Ign amp I'm guessing lives in steering column cowling?
No, the ignition amplifier should mounted on the same bracket as the coil
(or on the distributor body on early cars)
Easy enough to replace, but get a Lucas one as some of the pattern units aren't so good

dog man

Original Poster:

552 posts

233 months

Monday 20th September 2010
quotequote all
Cool guys that should get me started, excellent.

dog man

Original Poster:

552 posts

233 months

Sunday 10th October 2010
quotequote all
Problem never returned, I read in the bible that contaminated fuel can cause this.

walt762

240 posts

263 months

Sunday 10th October 2010
quotequote all
Another possibility is the immobiliser starting to go, I had that a few times & then it cut out permanently had to get a repacement from Carl.

MikeTVR

167 posts

314 months

Monday 11th October 2010
quotequote all
This is an extremely common issue on the Chimaera and is likely to come and go if not sorted. I've been wrestling with it for years (10 years) and have finally come to the conclusion that it is related to electrical noise which is exacerbated by poor earthing which is also a common issue with the Chimaera. Check the earthing straps from the engine, particularly the one under the offside wheel arch which is subject to corrosion. The other is more difficult to get at - it's a collection of cables connected to a point somewhere between the plenum and the bulkhead on the nearside of the engine. If you have a fairly old battery it will have a higher internal resistance yielding less capacity for suppressing electrical noise so replacement could help.
It's usual for everyone to blame the stepper motor which adjusts the idle speed, but I believe that this is alot more reliable than people give it credit for - it's still worth a clean.
Mike

loadblower

793 posts

266 months

Tuesday 12th October 2010
quotequote all
For me it was a dodgy ECU, for two years I had intemitent and random cut out.

Before discovering the real cause, I replaced coil, fuel pump, immobiliser, fixed wiring etc!

It is a real pain, but a process of deduction may help, though possibly expensive. I think some causes are more likely than others....

MikeTVR

167 posts

314 months

Tuesday 12th October 2010
quotequote all
loadblower said:
For me it was a dodgy ECU, for two years I had intemitent and random cut out.
From one ECU to another they are likely to have slightly different tolerance to electrical noise, so my theory still holds - your first ECU may just have had a marginally lower tolerance.
The ECU has a little circuit known as a watchdog which monitors a specific output from the processor. When the processor crashes the watchdog responds very quickly to the loss of output from the processor and reboots it in a few tens of milliseconds. When the processor restarts it will reset the stepper motor to some start state that won't be the ideal place when you pull up at the next junction. As the idle control doesn't try to correct itself until road speed is seen as zero, by the time you're at zero the engine has already cut out. Oscillating idle at standstill could also be caused by repeated ECU watchdog resets.

I have certainly noticed little hesitations / misfires when I've had the iding problem in the past and I've picked up on at least one other persons similar comments in this respect.

I have now fitted a large electrolytic capacitor (47,000uF 40V) between the main ignition lead (ignition relay) and the -ve lead of the battery and touch wood things have been very stable over this summer season.
Mike

loadblower

793 posts

266 months

Tuesday 12th October 2010
quotequote all
Mike,

Thats interesting. I'm not an expert at all in electronics or ECU, it has been an experience I can tell you!

Had Austec sort it for me in the end, turns out that the ECU had a transistor issue that was dumping the fuel pump in and out at will. On one such occassion I rolled to a halt, only to hear the fuel pump priming and then turning itself off of its own accord! What caused this begs the question, you could be on to something...

With this sort of thing its easy to lose patience, when you have one tiny item otherwise letting down a sound car.




dog man

Original Poster:

552 posts

233 months

Thursday 14th October 2010
quotequote all
Well I'm off round Europe on Sunday so I hope it doesnt come back! lol!

loadblower

793 posts

266 months

Thursday 14th October 2010
quotequote all
Good luck!

Don't forget your spares kit...

dog man

Original Poster:

552 posts

233 months

Thursday 14th October 2010
quotequote all
Will do!