Pulley-wheel
Pulley-wheel
Author
Discussion

Teetertank

Original Poster:

358 posts

218 months

Monday 20th September 2010
quotequote all
When attempting to fit a trigger-wheel at the weekend, found that the pulley wheel is cracked along the key-way, plus the rubber insert is quite perished. So the assembly needs replacing.

I’m aware of the balancing issue for these engines (5.0), and nervous that I don’t upset the balance and end up with serious issues.

On the pulley assembly there is a separate plate which has a thick bead welded round some of the perimeter – there is also a number stamped on a plate of this. I take it that this is the weighting necessary to balance the pulley-wheel and engine as a whole?

So, my question is, if I order a replacement pulley/damper assembly, then take off and fit the balancing “plate” off my original one, will the engine remain balanced?

Have seen that Spend and others on here have recommended a John Eales pulley-wheel which is fluid damped. Does this mean it will take care of any balance issues? And can anyone confirm if the trigger-wheel I have for the existing pulley would fit the bolt arrangement on the John Eales wheel?

Thanks

rev-erend

21,624 posts

315 months

Monday 20th September 2010
quotequote all
I have the JE crank pulley. It's not fluid damped.

The TVR engine was balanced externally - with front pulley and flyweel attached
and made by drilling and adding weights as necessary.

Ideally you would not change any component without rebalancing.

Proper inspection of the part would be necessary because replacement without a fully balance is a risk.


Meatball

1,638 posts

241 months

Monday 20th September 2010
quotequote all
Speak to V8D they have a guy who balances them for about £40-£50.

Teetertank

Original Poster:

358 posts

218 months

Monday 20th September 2010
quotequote all
rev-erend said:
The TVR engine was balanced externally - with front pulley and flyweel attached
and made by drilling and adding weights as necessary.

Ideally you would not change any component without rebalancing.

Proper inspection of the part would be necessary because replacement without a full balance is a risk.
Ok, thanks for that Rev.

To me it looks like the harmonic balancer is balanced from drill holes as you say. Presumably, not all RV8s are externally balanced, but they do balance the harmonic unit as standard, albeit on it's own.

If that's the case, then the TVR engine would have had a pre-balanced harmonic balancer, and then the whole engine was balanced by the weld metal/studding etc added to the separate plate.

...so my theory is that any harmonic balancer is balanced, and therefore if I replace that part but keep the original welded plate and install in the keyed position then wouldn't that keep the engine balanced?

It's just sounds to me like getting the whole engine rebalanced is a big job, and needs the engine out of the car - something I prefer to avoid.