new coil and dizzy
Discussion
im after a new coil and dizzy for the chim (500) but dont really know which ones to get. are there standard parts and upgraded parts? which is best to get and is it as simple to fit as it looks or will it take a bit of playing around. ive checked on some parts websites and they seem only to sell standard parts. ultimately it dosent matter if it stays standard im just after a new coil and dizzy.
any help would be great Shaun.
any help would be great Shaun.
Ozmira said:
im after a new coil and dizzy for the chim (500) but dont really know which ones to get. are there standard parts and upgraded parts? which is best to get and is it as simple to fit as it looks or will it take a bit of playing around. ive checked on some parts websites and they seem only to sell standard parts. ultimately it dosent matter if it stays standard im just after a new coil and dizzy.
any help would be great Shaun.
All bog standard range Rover / Land rover parts. Just be aware of some of the low cost pattern parts out there however.any help would be great Shaun.
Just a second thought, there is some discussions if TVR changed the springs and wieghts in the dizzy ( I dont know if they did) so you might need to swap these bits over if they are different. Mind you it would be better to spend your money on mapped ignition system and coil packs rather than replace outdated stuff with new bits.
Edited by blitzracing on Friday 24th September 14:52
[quote=blitzracing
Just a second thought, there is some discussions if TVR changed the springs and wieghts in the dizzy ( I dont know if they did) so you might need to swap these bits over if they are different. Mind you it would be better to spend your money on mapped ignition system and coil packs rather than replace outdated stuff with new bits.
[/quote]
Mark... is there a unit out there where you can do this but keep the 14cux?... from thoes I've looked at so far they all tend to go with a new ECU?...
Just a second thought, there is some discussions if TVR changed the springs and wieghts in the dizzy ( I dont know if they did) so you might need to swap these bits over if they are different. Mind you it would be better to spend your money on mapped ignition system and coil packs rather than replace outdated stuff with new bits.
Edited by blitzracing on Friday 24th September 14:52
[/quote]
Mark... is there a unit out there where you can do this but keep the 14cux?... from thoes I've looked at so far they all tend to go with a new ECU?...

blitzracing said:
Interesting... and cheaper than a new dizzy.... and looks like it ties up with the MS ECU's if you want to go further... I did look for the MJ control unit before but didn't find this page for some reason??... I think a mapped spark would give a good improvement over std?.. just wonder what control you have and can you have a couple of settings?.. Reason I ask is I've played about with the vac tapping on the plenum and it does make a differance... closer to the butterfy gets the spark advanced quicker so better for slow running and reduced shunting... 2mm from the butterfly and it goes a lot better but will bounce about a bit...
Any idea if you could have 2 maps?.. do they work in the same way as an ECU with regards to mapping?
I think the price £289 is the lower one,,, no thats £246... it's £331 for the V8... I'm sure it said £289 first time I looked??????? do they have web site issues?? Or has it JUST gone up by £42!!

Edited by TVR Beaver on Sunday 26th September 15:58
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




Its nearer £400 for the V8, but I know when I looked at this previously I reckon you could source the bits from the USA at lot cheaper (like the coil packs and Ford trigger units) if you want to spend the time.