Mixed up HT leads
Discussion
Called out a very well known recovery firm on Friday due to a flat battery and foolishly left the bloke alone with my car. To cut a very long and depressing story short the car still would not fire with a jump start and he decided to check the spark plugs. Knock at the door 15mins later to say " Er, I can only get 7 of the plugs to go back in and i've no idea which ht lead goes to which plug ". I told him to leave.
So now I still have a flat battery, have to refit the plugs and no idea which HT lead is which.
Any advice on how sort the leads out much appreciated. Searched the forum to no avail.
Cheers
So now I still have a flat battery, have to refit the plugs and no idea which HT lead is which.
Any advice on how sort the leads out much appreciated. Searched the forum to no avail.
Cheers
Distributor may not be as per the pic - the firing order is correct but you may need to work out which is cylinder 1.
Take No1 spark plug out & turn engine over with a socket / bar with your finger over the spark plug hole until you feel the pressure building, then look at the timing marks and continue to turn it till they are at TDC.
The rotor arm will now be pointing at cylinder 1.
If you don't have the right socket it can be done with the car in 5th gear & handbrake off & pushing it to turn the engine, it's not very elegant though
Take No1 spark plug out & turn engine over with a socket / bar with your finger over the spark plug hole until you feel the pressure building, then look at the timing marks and continue to turn it till they are at TDC.
The rotor arm will now be pointing at cylinder 1.
If you don't have the right socket it can be done with the car in 5th gear & handbrake off & pushing it to turn the engine, it's not very elegant though

Edited by Barkychoc on Sunday 26th September 13:39
Gassing Station | Chimaera | Top of Page | What's New | My Stuff






