Fuel Pump Primes, but nothing when key is turned
Fuel Pump Primes, but nothing when key is turned
Author
Discussion

Milky400

Original Poster:

1,960 posts

209 months

Wednesday 29th September 2010
quotequote all
Had issues last night after i had returned to the car after aquick pint! unlocked the car, turned the key all lit up and pump primed but that was it.

AA where as much use as a choclate condom they said there was definately power at the starter, but i have checked and there is no power there now.

Does the immobiliser immobilise the starter?

Any Ideas greatly recieved

cheers Mark

Edited by Milky400 on Wednesday 29th September 11:22

BrianMillar

192 posts

236 months

Wednesday 29th September 2010
quotequote all
I have a 98 Chim 500 fitted with the original Meta system alarm and immobiliser.
As far as I know this type of immobiliser isolates 3 circuits on the car

ECU
Ignition
Fuel Pump relay (control circuit)


Milky400

Original Poster:

1,960 posts

209 months

Wednesday 29th September 2010
quotequote all

have power at the coil, and full pump primes just dead at the starter

BrianMillar

192 posts

236 months

Wednesday 29th September 2010
quotequote all
I think that what I described above as the ignition circuit is actually the starter circuit
I am at work at the moment so I haven't got access to all my notes to check.

The wire for the starter circuit as I remember is white with red trace (White/Red)

There are a few places to check for power to the start circuit.

1. At the back of the ignition switch(in start Position)
2. At the connector block to the immobiliser
3. At the starter solenoid terminal.

The test at the connector block to the immobiliser will tell you if you have an immobiliser problem.
If you need more details I can PM you but I don't think it's a good idea to post more detailed info than I have.


Milky400

Original Poster:

1,960 posts

209 months

Wednesday 29th September 2010
quotequote all

Please do PM me i shall have another look tonight when i return from work.

Cheers

Stiggly

33 posts

195 months

Wednesday 29th September 2010
quotequote all
From my experience it could be the 'hot start' problem (perhaps just the fuse in the hot start kit if one has already been fitted), the starter motor needing a gentle tap with a hammer or the car rocking whilst in gear, or a failing ignition switch - or perhaps all three!

If it was the immobiliser the fuel pump wouldn't kick in.

Milky400

Original Poster:

1,960 posts

209 months

Wednesday 29th September 2010
quotequote all

Starter been hit several times, and rocked with no joy starter not even turning as there seems to be no power to it. Not had a hot start issue since i've had the car, and it has had the kit fitted but will check this.

BrianMillar

192 posts

236 months

Wednesday 29th September 2010
quotequote all
I have sent you a PM

One further thing have you tried jumpering a feed from the main live terminal on the starter to the solenoid terminal? This will prove if the starter is jammed.

spend

12,581 posts

282 months

Wednesday 29th September 2010
quotequote all
Yes the immobilizer cuts power to the starter solenoid.

As mentioned earlier just stick +12v to the spade terminal on the starter and the starter should fire up (easy to make up a 20A push switch linking the starter to the alternator pole to check).

Fuel pump is normal, controlled by the ECU it first primes and then has a break until the ECU sees starting rpm's.

Milky400

Original Poster:

1,960 posts

209 months

Wednesday 29th September 2010
quotequote all
Big Thankyou to Brian for the PM much appriciated, ended up connecting 12v supply to the starter direct and dead as a dodo

Managed to get the guys at Techniques Motorsport to source and fit a starter this afternoon top guys and not to pricey!!!!

Again thanks guys

BrianMillar

192 posts

236 months

Thursday 30th September 2010
quotequote all
Good to hear you got it sorted

mgjc

129 posts

207 months

Thursday 30th September 2010
quotequote all
I have a similar issue - any thoughts to this one.

This only seems to happen once i've used the car (so it's warm) and I've stopped with engine off. I've had the 'hot start' mod fitted (about 6 months back now) as I was experiencing it almost all the time and it fixed it straight off - so happy motoring! However in the last 2 months the following has started to happen and its intermitent too.

When I turn the ignotion key, the fuel pump kicks in but no start up. However if I hold the key in the "ignition fire" position and keep it held thers, after about 20 - 30 seconds it fires up and I'm good to go.

I'm at a lost as to why holding the key this way for such a long time works.

Any ideas?

spend

12,581 posts

282 months

Thursday 30th September 2010
quotequote all
That sounds like the ignition switch itself 'burnt out' - check the spade terms on the back of the switch to start with (but TBH a new switch on hand is probably easier once you've got that far?)

mgjc

129 posts

207 months

Friday 1st October 2010
quotequote all
spend said:
That sounds like the ignition switch itself 'burnt out' - check the spade terms on the back of the switch to start with (but TBH a new switch on hand is probably easier once you've got that far?)
cheers - I assume its the standard vauxhall part that's listed on the Chimaera pages.

BrianMillar

192 posts

236 months

Monday 4th October 2010
quotequote all
mgjc said:
cheers - I assume its the standard vauxhall part that's listed on the Chimaera pages.
Vauxhall part No. 90052497 is for the ignition switch only (not the lock barrel). I got one a couple of weeks ago. Less than £20 from my local Vauxhall dealer. You can get one much cheaper from an online Vauxhall spares place.


P400PLS

404 posts

258 months

Saturday 9th October 2010
quotequote all
mgjc,

Any update on the symptoms you described.

My car has the same condition and after reading your post I have held the key in the start position and then all of a sudden it turns over.

Would be interested to know if it was the switch ?


BryanWilton

196 posts

234 months

Tuesday 12th October 2010
quotequote all
I had a similar problem, fuel pump primed, turned ignition key & nothing happened. It only used to happen when the car was hot. Leave it a few minutes to cool down & the car started fine...

I bought the hot start mod & fitted, no more problems for a couple of months & then it started happening again when the car was cold.

When I punched the underside of the dash on the passenger side of the car, the car started (this is where the immobiliser sits). This was freeing up the sticking immobiliser relay...

I spoke to Carl Baker who diagnosed it as a faulty immobiliser over the phone & the hot start kit had done nothing but mask the real problem, which was the immobiliser all along. Popped down to Carls & had a new immobiler fitted, no more problems since :-)