Help, fan problem testing my patience!
Discussion
As above, my new to me Chim had a problem with the fans not cutting out when I bought her, & I thought I had traced the problem to a dodgy connection. So for a few days she was fine, but for the last 2 days has gone back to the fans staying on when I leave the car, & staying on until they drain the battery. Had a real palarva getting in her with a totally flat battery, but managed to do so, start her & get her home, but she is parked outside, the fans whizzing like mad, well until they flatten the battery again of course. I though if I disconnected them they would stop, but do they bugger!!
Can anyone help me with a solution please?
It would be lovely if the search function worked wouldn't it?
Thanks for any help.
Can anyone help me with a solution please?
It would be lovely if the search function worked wouldn't it?
Thanks for any help.
I'm sorry fella I don't know where it would be. Do you have a main fuse/relay box in the engine bay? That's where I would start looking.
If it's like an Elise for example it may be a multi function relay, but I'd be suprised.
Maybe a quick ph google search might bring something up on it's location.
Sorry I can't be of much more help.
Tim.
If it's like an Elise for example it may be a multi function relay, but I'd be suprised.
Maybe a quick ph google search might bring something up on it's location.
Sorry I can't be of much more help.
Tim.
Does this help? http://www.chimaerapages.com/resources_manual_fan....
Good point. I had a look and found this on http://www.rv8r.co.uk/overheatingsurvey.html
- Take the wires off the fan switch at the bottom of the swirl pot and connect the terminals together. If the fans don't start when you turn the ignition on, there is a fault in the fan fuse, the relay (which is on the main panel in the passenger footwell) or the switch itself.
- The fan (otter) switch is easy to replace but make sure you get the correct 98/93 degree unit and don't try to do it when the engine's hot!
So if you take the wires off the fan (otter) switch and hold them apart, and turn on the ignition, do they stop?
Now if the fans run with the ignition OFF, it would imply they're wired to continue running while the engine cools. I can see I'd have fun with a Chim...
ETA: Also this from a PH thread: "Basically, the fan relay is earthed via the otter switch, pretty sure the black from the otter switch picks an earth up on the Alternator"
- Take the wires off the fan switch at the bottom of the swirl pot and connect the terminals together. If the fans don't start when you turn the ignition on, there is a fault in the fan fuse, the relay (which is on the main panel in the passenger footwell) or the switch itself.
- The fan (otter) switch is easy to replace but make sure you get the correct 98/93 degree unit and don't try to do it when the engine's hot!
So if you take the wires off the fan (otter) switch and hold them apart, and turn on the ignition, do they stop?
Now if the fans run with the ignition OFF, it would imply they're wired to continue running while the engine cools. I can see I'd have fun with a Chim...
ETA: Also this from a PH thread: "Basically, the fan relay is earthed via the otter switch, pretty sure the black from the otter switch picks an earth up on the Alternator"
Edited by -Pete- on Thursday 30th September 22:58
Colin RedGriff said:
Relay is a fairly common type - should be avaialble at most auto factors
Trying to do this today, but my local factors stock relays are not quite the same, one of the pins has a slightly different value, My relay has values 30-85-86-87, & their nearest is 30-85-87-87.Does anyone know if that makes much difference? I wouldn't have thought that the fans would draw much current?
Cheers.
The overheating survey was conducted by Peter Beech and nearly caused TVR to stop me doing the Griff bible as it implied that all TVRs overheated and the problems were down to poor design when the reality was component failures in the cooling system. Such was Peter Wheeler's anger that he threatened to stop anyone writing anything mechanical on his cars, including the TVRCC and me. Managed to placate him but it was a close run thing.
For example, the problem was not helped by the temperature figures that were quoted were INCORRECT along with a lot of other stuff. Where those figures came from is a mystery but they have probably caused more problems/issues than they have solved. For example:
For example, the problem was not helped by the temperature figures that were quoted were INCORRECT along with a lot of other stuff. Where those figures came from is a mystery but they have probably caused more problems/issues than they have solved. For example:
-Pete- said:
- The fan (otter) switch is easy to replace but make sure you get the correct 98/93 degree unit and don't try to do it when the engine's hot!
No... the 98/93 degree otter switch is fine for a LAND ROVER or a RANGE ROVER but it is the wrong one for a TVR. Fit it and the car will over heat as the fans need to come on at a lower temp than that. See page 135 in't bible...Speedracer329 said:
Colin RedGriff said:
Relay is a fairly common type - should be avaialble at most auto factors
Trying to do this today, but my local factors stock relays are not quite the same, one of the pins has a slightly different value, My relay has values 30-85-86-87, & their nearest is 30-85-87-87.Does anyone know if that makes much difference? I wouldn't have thought that the fans would draw much current?
Cheers.
I suspect the problem is either the wrong relay or one with sticky contacts. It is possible that someone has modded the wiring so that the fans run after the ignition is turned off. The water doesn't circulate and the otter switch stays switched on and the battery stops.
shpub said:
For example, the problem was not helped by the temperature figures that were quoted were INCORRECT along with a lot of other stuff. Where those figures came from is a mystery but they have probably caused more problems/issues than they have solved.
Mystery solved shpub: "1997 Overheating Survey Results - This is based on a questionnaire which I sent to Sprint in April." 31 chim and griff owners responded. From http://www.rv8r.co.uk/overheatingsurvey.htmlYes I know the figures came from there - I even have the original submission in Sprint. I think I even have the questionnaire as well and IIRC it didn't ask anything about what was the correct temperature for the otter switch etc. Where that information came from is still a mystery as it certainly didn't come from the owners. The bit about the dealers saying that the "fans do not come on until 100C" is really strange as that is a real fault. Where the author got that information from is still quite mysterious.
Edited by shpub on Sunday 3rd October 10:58
I had this little problem a few weeks ago......
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
To stop the fans unplug them right near the bottom of the fans, you should see two white rectangular plugs, this will stop them whirring.
I then got in the footwell and swapped the horn relay and the fan relay, they are exactly the same, the filofax handbook has a diagram of which are which.
http://www.pistonheads.com/gassing/topic.asp?h=0&a...
To stop the fans unplug them right near the bottom of the fans, you should see two white rectangular plugs, this will stop them whirring.

I then got in the footwell and swapped the horn relay and the fan relay, they are exactly the same, the filofax handbook has a diagram of which are which.

Gassing Station | Chimaera | Top of Page | What's New | My Stuff




