Magnacor leads
Magnacor leads
Author
Discussion

rabowman

Original Poster:

284 posts

219 months

Friday 1st October 2010
quotequote all
Fitted new leads yesterday, and when taking old ones out from the dizzy, noted that the dizzy was fitted with a unit in each hole that raises the leads up. (Cor real technical!!) What are they for, and do i need them?
Tks
Rob

blitzracing

6,422 posts

251 months

Friday 1st October 2010
quotequote all
There is a very specific routing for the leads across the top of the cap to prevent cross firing between the leads, so some leads come straight up and some at 90'. I dont know of these items in question, but it may answer the question.

dumbfunk

1,727 posts

315 months

Friday 1st October 2010
quotequote all
This is interesting! My car has magnacor leads (4+ yrs old) with the straight/right angles fitted by convenience rather than design. I have experienced serious misfire in very wet weather and wonder whether this could be an issue.

The most recent time was driving in Slovenija with lakes of water on the motorway. The car ran perfectly until I stopped for 20 minutes to grab a coffee and from then on it was misfiring disastrously on part throttle. Dried out, fine again.

Any idea where I could find out the correct fitting to double check?


Thanks



df

rabowman

Original Poster:

284 posts

219 months

Friday 1st October 2010
quotequote all
Spoke to Clever Trevor whilst ordering more goodies, and he thinks that they may be additional suppressors, and suggests that I remove them.

Chimpaholic

9,637 posts

210 months

Friday 1st October 2010
quotequote all
I found these little critters on my dizzy when I replaced my leads with a Magnacore set.

Like you I wasn't sure exactly why they were there.

I removed them, fitted my new leads and the car ran great.

I would just bin them like I did.


blitzracing

6,422 posts

251 months

Friday 1st October 2010
quotequote all
Magnacore leads can cause some nasty gliching in the coils primary circuit, that can make the rev counter glitch, and increases the back EMF the ignition amp has to deal with. Suppressors will overcome this issue, but you might as well have fitted a decent set of Bosch leads for £25 in the first place that are resistively suppressed in their construction. In answer to Dumbfunk, I would not blame the Magnacors for water ingress unless they are damaged as the 4x4 boys seem to like them as they dont short out at the first puddle.

Chimpaholic

9,637 posts

210 months

Friday 1st October 2010
quotequote all
blitzracing said:
Magnacore leads can cause some nasty gliching in the coils primary circuit, that can make the rev counter glitch, and increases the back EMF the ignition amp has to deal with. Suppressors will overcome this issue, but you might as well have fitted a decent set of Bosch leads for £25 in the first place that are resistively suppressed in their construction. In answer to Dumbfunk, I would not blame the Magnacors for water ingress unless they are damaged as the 4x4 boys seem to like them as they dont short out at the first puddle.
I have had absolutely no rev counter problems with my Magnacore leads.

Or any other problems with the leads for that matter.

Just smoother running.

Perhaps those that suffer the rev counter problem should experiment with altering their chosen lead routing slightly?

Just a thought.

ACT

2,529 posts

315 months

Friday 1st October 2010
quotequote all
you can remove the little dissy supressors, they aren't required.

rabowman

Original Poster:

284 posts

219 months

Saturday 2nd October 2010
quotequote all
Thanks, critters removed but not yet binned. From memmory it is only leads 5 and seven that must not touch.
Rob

blitzracing

6,422 posts

251 months

Saturday 2nd October 2010
quotequote all
Chimpaholic said:
blitzracing said:
Magnacore leads can cause some nasty gliching in the coils primary circuit, that can make the rev counter glitch, and increases the back EMF the ignition amp has to deal with. Suppressors will overcome this issue, but you might as well have fitted a decent set of Bosch leads for £25 in the first place that are resistively suppressed in their construction. In answer to Dumbfunk, I would not blame the Magnacors for water ingress unless they are damaged as the 4x4 boys seem to like them as they dont short out at the first puddle.
I have had absolutely no rev counter problems with my Magnacore leads.

Or any other problems with the leads for that matter.

Just smoother running.

Perhaps those that suffer the rev counter problem should experiment with altering their chosen lead routing slightly?


Just a thought.
Its all pretty marginal, as when the coil is switched off by the amp to produce the spark, the collapsing magnetic fields also produce several decaying high voltage spikes (peaking at about 300v) on the 12 volt side of the coil, in an effect known as ringing. Your rev counter picks up the biggest spike to get a reading of the RPM, and ignores the lower spikes. If you reduce the resistance in the secondary part of the circuit (ie HT leads) the spikes are bigger, so you could get a 450v spike followed by a 300 v spike, so the rev counter sees now two pulses for one spark, so it jumps about. Its not consistent as the variable conditions in the combustion chamber alter the voltage the spark jumps at, which also alter the primary spikes. The absolute worse thing you could use is plain copper HT leads, which effectively cause the coil to short out when the spark starts, so you get a very hot, but very brief spark, and the voltages in the primary might well reach 600 volts, which will overstress any semiconductor switches (ie the Amp) on the primary, and also produce lots of radio interference that can upset any local electronics (ie your ECU). This is why HT leads are high resistance to control the discharge rate and spark duration. The Magnecores do provide some suppression and resistance, and as an "end user" you would not notice the changes in these signals unless you look for them, and on the whole the stock electronics can cope, but I would not fit them out of choice as there is nothing to be gained over decent stock leads on an RV8. Magnecore don’t make any false claims at all about the leads if you read their technical blurb, its just more urban myth however that they are a must have on a TVR!