Discussion
I've begun to notice a dodgy smell in my Chim which appears to be due to some water ingress around the front of the drivers door. I've had a look at the seal and it looks ok, but somehow water has run over it and gone underneath (I think). It's been fine for years with no leaks so all I can think of it that the seal is not doing as good a job as it used to. So I've looked at Racetech Direct's site and they seem to sell the appropriate seals, but I'm not sure how much I need for each side? Any ideas? Or suggestions on any other sources of water ingress!
I need to replace the seals on my Griff but mine are visably ill fitting - particularly where the door seal goes virtually horizontal round where the dashboard is - that is my prime suspect at the moment.
Can you trace exactly where the water is getting in by where the carpet is wet? Could be worth putting a drain hole in the outer part of the seal at each end of the sill - apparently water can build up here from the door drain holes and spill over the top of an otherwise good seal into the car. There's some pictures on here somewhere...
Edit - just had a look - racetech reckon you need 7metres all the way around - the seal in my previous Griff was cut at the top of the windscreen so you could just do driver side?
Also found the seal piccies - http://www.pistonheads.com/gassing/topic.asp?h=0&a... HTH
Can you trace exactly where the water is getting in by where the carpet is wet? Could be worth putting a drain hole in the outer part of the seal at each end of the sill - apparently water can build up here from the door drain holes and spill over the top of an otherwise good seal into the car. There's some pictures on here somewhere...
Edit - just had a look - racetech reckon you need 7metres all the way around - the seal in my previous Griff was cut at the top of the windscreen so you could just do driver side?
Also found the seal piccies - http://www.pistonheads.com/gassing/topic.asp?h=0&a... HTH

Edited by JamesK on Wednesday 6th October 09:50
The old trick for checking door seals for water ingress when I was "in the trade" was to shut a strip of paper in the door, if it grips seal should be ok but if it pulls out easy seal is not compressed enough. takes a while to work around door aperture but quite effective. With a steel body its easy to bent the flange out a little to tighten the fit, not so easy with fibreglass ?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


