WOO! finally actually tracked down a noise!!!
WOO! finally actually tracked down a noise!!!
Author
Discussion

darkcat

Original Poster:

2,354 posts

201 months

Friday 8th October 2010
quotequote all
Since i had my clutch done last week, every time i start from cold there has been a thump sound as the engine fires up and had a good jiggle.

tracked it down last night - engine mounts are shagged, causing the engine to sit about 1cm lower than normal, this in turn allows the pre-cat to knock on the top wishbone mounting point :-)


Now i need new engine mounts, where is the CHEAPEST place to get them from?? ive seen them on racing green at £40 EACH, which is rather steep for a block or rubber and metal... someone said they should be 15-20 each (standard SD1 mount i beleive)

and then for the fitting...

The plan is to take off my manifolds first to get to them from the top, and while im at it, re-do the manifold gaskets and remove the pre-cats.


SILICONE KID

14,997 posts

262 months

Friday 8th October 2010
quotequote all
Don`t forget the restraints RPI and TVR power sell them.

http://www.tvrpower.co.uk/store/filter/category/1/

Teetertank

358 posts

218 months

Friday 8th October 2010
quotequote all
Yeah they do seem expensive for what they are.

I ended up getting some poly mounts from some TVR place, but they were even more expensive -thought they would last longer, but the heat isn't good for them.

You should probably try some rover places for them - SD1.

Also, you don't need to remove the manifolds unless you really want to do the cats etc. They are quite easy to replace from below if you can jack up the engine.

MikeTVR

167 posts

314 months

Friday 8th October 2010
quotequote all
Teetertank said:
You should probably try some rover places for them - SD1.
I bought some SD1 mounts and one of them fell apart after a very short duration and I don't gun it that often. The rubber wasn't a solid block , it had holes through. I would think that Range Rover mounts would have better potential.
Mike