Nasty Discharge!!
Discussion
The old cavalier that donated the steering column, ignition switch etc used to have a common fault where the ignition (key operated) switch would wear inside with brass filings depositing inside the switch and causing conductivity between the terminals even with it turned off.
I've seen a cavalier where the engine would keep going when you took the key out!
Try taking the steering column cover off & disconnecting the ignition switch to eliminate this as a possibility.
I'm assuming that the switch has a connector to the loom?
If not you'll have to get a decent sized soldering iron on the job.
I've seen a cavalier where the engine would keep going when you took the key out!
Try taking the steering column cover off & disconnecting the ignition switch to eliminate this as a possibility.
I'm assuming that the switch has a connector to the loom?
If not you'll have to get a decent sized soldering iron on the job.
Edited by Barkychoc on Saturday 23 October 20:30
rabowman said:
Changed the alternator and the battery. Checked every fuse incl all in line ones.
Still got a 2amp leak.
HELP !!!
Very strange, Still got a 2amp leak.
HELP !!!
If you disconnect every fuse in turn with your meter on the battery you really should be able to find the source of your parasitic drain.
Well you should at least be able to significantly narrow your search down to a few likely culprits.
The point previously made about the courtesy light switches is a good one.
I would disconnect both door switches remove the live & earth from each and isolate them to completely to eliminate this as the source of the drain.
Tracing any electrical fault is really just a case of being systematic, you need to be disciplined in your method.
Making a logical list to help you follow a strict process of elimination is often the only way to make sure you haven't skipped a step.
Finally don't forget there is a constant drain from the ECU, disconnect it with your meter on the battery just as you have with each fuse.
The fact is all Chims seem to have a drain, some are worse than others, but a 2 amp drain is a bit naughty.
My tips would be.
1) Make a list on a piece of paper
2) Disconnect each component / fuse following your list while watching the meter
3) Mark each component / fuse on your paper list with the meter reading
In the end, if you are 100% disciplined in your systematic process of elimination and you keep a written record of each step you absolutely have to find the drain in the end.
Get bored, skip a few things, have too many tea breaks & fail to keep a written record you may never find te source of the problem.
That's why I was always a terrible auto electrician.
I blame it on my attention-deficit/hyperactivity disorder

Barkychoc said:
The old cavalier that donated the steering column, ignition switch etc used to have a common fault where the ignition (key operated) switch would wear inside with brass filings depositing inside the switch and causing conductivity between the terminals even with it turned off.
I've seen a cavalier where the engine would keep going when you took the key out!
Try taking the steering column cover off & disconnecting the ignition switch to eliminate this as a possibility.
I'm assuming that the switch has a connector to the loom?
If not you'll have to get a decent sized soldering iron on the job.
NOW THAT IS GOOD ADVICE.I've seen a cavalier where the engine would keep going when you took the key out!
Try taking the steering column cover off & disconnecting the ignition switch to eliminate this as a possibility.
I'm assuming that the switch has a connector to the loom?
If not you'll have to get a decent sized soldering iron on the job.
Edited by Barkychoc on Saturday 23 October 20:30
EVERYONE TAKE NOTE.
Barkychoc IS ABSOLUTELY CORRECT, I ACTUALLY REMEMBER FINDING THIS ONCE ON AN ASTRA.
WELL DONE MATE

EUREKA !!!!! Leak traced to faulty circuit in driver's courtesy light switch plus faulty reading in my meter. Cleaned up all contacts including solonoids, bought a new meter and now showing discharge of just 0.14 amp. Verified this by taking car to garage and checking with their meter.
Thanks for all the help and replies
Rob
Thanks for all the help and replies
Rob
rabowman said:
EUREKA !!!!! Leak traced to faulty circuit in driver's courtesy light switch plus faulty reading in my meter. Cleaned up all contacts including solonoids, bought a new meter and now showing discharge of just 0.14 amp. Verified this by taking car to garage and checking with their meter.
Thanks for all the help and replies
Rob
Congratulations that man! Thanks for all the help and replies
Rob

There is nothing quite like the sweet feeling of victory when you sort out your TVR wiring.
Please cash in your "smug points" now and enjoy them to the max
Well deserved.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




