Discussion
Thanks.Im tarting up the engine bay,The rocker covers are satin black(powder coated)just purchased steal braided efi 150c fuel pipe and s/steal braid for the breaher pipe and vac pipe to the plenum.Starting to look
prity.
fits perfect.Also fitted a TVR Power thermal insulator,don`t think its going to do much ,it looks like a bit of card board..Wanted the magna parva type but they only come in 38mm ,Know good for my beast.
http://cgi.ebay.co.uk/Stainless-Steel-Braid-Radiat...
prity.
fits perfect.Also fitted a TVR Power thermal insulator,don`t think its going to do much ,it looks like a bit of card board..Wanted the magna parva type but they only come in 38mm ,Know good for my beast.http://cgi.ebay.co.uk/Stainless-Steel-Braid-Radiat...

Edited by SILICONE KID on Friday 15th October 19:05
SILICONE KID said:
The s/steal braid fits perfect on both pipes .not like some ive seen.
Any thoughts on the TVR POWER thermal insulator.i have no after pics because it`s not finished
The 'fabric' insulator works well; just as well as the rigid type, the material is pretty techie and highly insulative.
Any thoughts on the TVR POWER thermal insulator.i have no after pics because it`s not finished
Edited by SILICONE KID on Friday 15th October 19:13
Grind the rocket cover so that the rubber gasket lip fits it nicely. Most of the cast covers seem to have very poor tolerance of thickness around the corners & one long edge.
You can glue the rubber gasket to the cover, most use a few dabs of evostick (ie thin contact adhesive not a filler) but this is really because you are fitting the things upside down (gravity is not on your side). Alternatively studs make dry assembly (vaseline surfaces still - a little lube ensures they don't gall when tightening down) a much easier procedure, just acquire long nuts.
You can glue the rubber gasket to the cover, most use a few dabs of evostick (ie thin contact adhesive not a filler) but this is really because you are fitting the things upside down (gravity is not on your side). Alternatively studs make dry assembly (vaseline surfaces still - a little lube ensures they don't gall when tightening down) a much easier procedure, just acquire long nuts.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



