Gears - What would cause....
Discussion
I see from your profile your car is a 1993 car so it will have the LT77 gearbox so...
1st step is to change the gearbox oil for this stuff....
Castrol SMX-S
See how that goes 1st.
1st step is to change the gearbox oil for this stuff....
Castrol SMX-S
See how that goes 1st.
Nosh said:
peaktorque said:
LT77?


Not sure about the LT77 linkage arrangement on Chims, but TVRs of the pointy nature are relative to SD1s, so replacement bushes are readily available from Rimmer bros....

pwd95 said:
I see from your profile your car is a 1993 car so it will have the LT77 gearbox so...
1st step is to change the gearbox oil for this stuff....
Castrol SMX-S
See how that goes 1st.
OK - just before I do this, is there a (copper?) washer that needs replacing when you change your gear oil?1st step is to change the gearbox oil for this stuff....
Castrol SMX-S
See how that goes 1st.
Thanks
Nosh
Quinny said:
I run a long pipe, down through the engine bay and into the gearbox filler hole..
Then shove a small funnel into the pipe, and get a helper to slowly poor the new oil down the pipe... Whilst I stay under the car and tell them when to stop
Quinny - done that mate - but only managed to get 2.5 litres of Castrolino SMX-S in it....Then shove a small funnel into the pipe, and get a helper to slowly poor the new oil down the pipe... Whilst I stay under the car and tell them when to stop

Anyways, getting 3rd is so much easier now from 2nd under hard acceleration.
Thanks
Nosh.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


