Chimera seats, can they be adapted to go further forwards ?
Discussion
Just drove a customers 1997 Chimera to its new owner, but the new owner is a lady of little height and the seat stops to far back for her to reach the pedals. Has anyone stuck different rails on the base or seat, or in some other way got the seat further forwards for shorter drivers ?
Thanks !
Thanks !
If its just the legs, screw the pedals out (they are adjustable). Leven used to do some extra long pedal replacements - someone might still have some they don't need?
You could move the runners forward, but the tub will need careful re-inforcement, and I'm not sure if there is enough room for the seat as the trans tunnel narrows the space available a bit?
You could move the runners forward, but the tub will need careful re-inforcement, and I'm not sure if there is enough room for the seat as the trans tunnel narrows the space available a bit?
The drivers seat is mounted on the floor (rear) and a small section of boxing (front) - at least it is in my 2000 model.
You could easily get someone who's handy with metal to fabricate a full-length section of boxing, whereupon you can mount the seat wherever you like. As long as the centre of gravity sits between the hole in the floor, should not be an issue.
Beware of getting in and out, though... I speak from personal experience because I did this to get a better view (I'm 5'5" on a warm day) and found my legs kept getting caught on the steering wheel.
I also took the opportunity to reinforce the mounts with metal beneath the car. When I lifted the seats out I was shocked at what was bearing my weight!!!
I have now returned to the original design because the extra height I added was too much.
In the end I swapped the driver and passenger seats around and discovered how much more my old drivers seat was sagging, and therefore how higher I sat in the (nearly unused) passenger seat.
Hope this is helpful,
Rich
You could easily get someone who's handy with metal to fabricate a full-length section of boxing, whereupon you can mount the seat wherever you like. As long as the centre of gravity sits between the hole in the floor, should not be an issue.
Beware of getting in and out, though... I speak from personal experience because I did this to get a better view (I'm 5'5" on a warm day) and found my legs kept getting caught on the steering wheel.
I also took the opportunity to reinforce the mounts with metal beneath the car. When I lifted the seats out I was shocked at what was bearing my weight!!!
I have now returned to the original design because the extra height I added was too much.
In the end I swapped the driver and passenger seats around and discovered how much more my old drivers seat was sagging, and therefore how higher I sat in the (nearly unused) passenger seat.
Hope this is helpful,
Rich
I have just taken the seats out my 1999 car, and found the passenger side seat on the floor , but the drivers side on two small box sections at the front only.
I am 6'3'' so I am going to refit as the passenger side directly to the floor for the drivers side also.
See if this gives me a bit more room.
Are the box sections at the front factory fitted for short drivers. My pedals are wound right up to the driver also.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



