Scraping Sound on Hill Starts??
Scraping Sound on Hill Starts??
Author
Discussion

Pacman1972

Original Poster:

327 posts

293 months

Sunday 17th October 2010
quotequote all
Not sure how to describe this one being non-technicalscratchchin.

When pulling away from a standstill with revs at about 3K and releasing the clutch slowly the car gives a kind of scraping sensation almost as if something isnt lubricated properly. Nothing too alarming but you can hear it and these is mild feedback through the pedels. It's more noticable when under strain, e.g. hill start and seems to be worse when hot and is accompanied but a bit of clunking from the rear when at lower speeds in high gears.

Ring any bells with anyone?

Edited by Pacman1972 on Sunday 17th October 21:06

Barkychoc

7,848 posts

235 months

Sunday 17th October 2010
quotequote all
Pacman1972 said:
and is accompanied but a bit of clucking
hehe Have you got a chicken stuck in the boot? Sorry rolleyes

SILICONE KID

14,997 posts

262 months

Sunday 17th October 2010
quotequote all
Sorry i don~t know CHICK jester

markreilly

795 posts

203 months

Sunday 17th October 2010
quotequote all
I'd say the scrapping noise is the chicken looking for something to eat.....chuck some grain out the window as you pull away,should cure the problem

Edited by markreilly on Sunday 17th October 20:58

madasafrog666

210 posts

199 months

Sunday 17th October 2010
quotequote all
Must be a free range chicken ,they get everywhere!!biggrin found two in the boot of the chim todayhehe

Pacman1972

Original Poster:

327 posts

293 months

Sunday 17th October 2010
quotequote all
Barkychoc said:
Pacman1972 said:
and is accompanied but a bit of clucking
hehe Have you got a chicken stuck in the boot? Sorry rolleyes
biglaugh - Oh Boy - That's gone and taken the thread in whole new direction. I do have chickens as it happens - I've checked and they're all accounted for biggrin

But seriously though if there is any chance to salvage this thread anyone got any ideas on what this might be?


Edited by Pacman1972 on Sunday 17th October 21:13

Barkychoc

7,848 posts

235 months

Sunday 17th October 2010
quotequote all
Sorry back to the plot then - I'm not a chim expert but I see plenty of posts about diff mounts - chim boys could it be a diff mount problem?

John042

904 posts

200 months

Monday 18th October 2010
quotequote all
I've just had Chicken for dinner and the noise has gone! Sorry Barkychoc these threads do head off in various directions. Before I took mine off the road for the winter I did experience a similar noise to yours. It seemed to vary with road gradients and sometime was not there at all. My first thoughts turned to clutch problems but deleted that idea after really abusing the clutch on hill starts. On advice my attention is now going to concentrate on the diff' mounting. There is a cage that supports the diff' bolted to the chassis. I add this on advice. I just hope it's not a drive shaft problem. Hope this helps. John042

Pacman1972

Original Poster:

327 posts

293 months

Monday 18th October 2010
quotequote all
John042 said:
I've just had Chicken for dinner and the noise has gone! Sorry Barkychoc these threads do head off in various directions. Before I took mine off the road for the winter I did experience a similar noise to yours. It seemed to vary with road gradients and sometime was not there at all. My first thoughts turned to clutch problems but deleted that idea after really abusing the clutch on hill starts. On advice my attention is now going to concentrate on the diff' mounting. There is a cage that supports the diff' bolted to the chassis. I add this on advice. I just hope it's not a drive shaft problem. Hope this helps. John042
That does sound similar - There is a slight rattle coming from underneath when going over bumps so I'm hoping its something simple. Drive Shaft was what initially sprung to mind as it does seem to come from the front and travel through the center of the car. As you say it's not always there - Maybe something out of alignment?

darkcat

2,354 posts

201 months

Monday 18th October 2010
quotequote all
could it be something to do with the exhaust mounting plate? Mine had a bit of a rattle 'till i bent it streight.