Couple of issues
Discussion
After a little help
1. Interior door release knob was loose ( I thought ) got allen key for small grub screw that secures
the alloy knob to spindle. Seems the knob is secure and it looks like the spindle / pulley mechanism
that opens the door is loose. I can move the hole spindle from side to side and back and forth. Has anybody any pics of how this pulley mechanism is secured before I start taking things to bits.
2. When car is warm but not hot say when I have stopped for approx 30 mins after a run, when I come
to re-start engine revs to approx 2000 revs the dies down to tick over after about 10 seconds.
When hot it seems to start fine ie normal tick over. Just worried that oil might not be pumped round
fast enough when at 2000 revs.
Dont know if it makes a difference but W reg 25000 miles and serviced regular.
Any help would be appreciated
Col
1. Interior door release knob was loose ( I thought ) got allen key for small grub screw that secures
the alloy knob to spindle. Seems the knob is secure and it looks like the spindle / pulley mechanism
that opens the door is loose. I can move the hole spindle from side to side and back and forth. Has anybody any pics of how this pulley mechanism is secured before I start taking things to bits.
2. When car is warm but not hot say when I have stopped for approx 30 mins after a run, when I come
to re-start engine revs to approx 2000 revs the dies down to tick over after about 10 seconds.
When hot it seems to start fine ie normal tick over. Just worried that oil might not be pumped round
fast enough when at 2000 revs.
Dont know if it makes a difference but W reg 25000 miles and serviced regular.
Any help would be appreciated
Col
The starting /idle issue doesn't sound like much to be concerned about. The cold start increases revs initially and then it gradually reduces. To be absolutely sure you would need to know what the actual temeratures are when car has been left. Has the stepper motor been cleaned recently?
If you havent already done so, try the search facility (which i see is now up and running again) for idle speed (use the advanced search / chimeara section). Might be something in there of interest.
Someone with more detailed knowledge might add more later.
If you havent already done so, try the search facility (which i see is now up and running again) for idle speed (use the advanced search / chimeara section). Might be something in there of interest.
Someone with more detailed knowledge might add more later.
The door opener is held in place by two or three screws.
You need to unscrew the center console to lift it up and have a look underneath.
There are two screws at the front (one each side of the tunnel right at the front of the leather bit that points towards the footwell) and one at the back under the flap in the small storage bit.
You need to unscrew the center console to lift it up and have a look underneath.
There are two screws at the front (one each side of the tunnel right at the front of the leather bit that points towards the footwell) and one at the back under the flap in the small storage bit.
Edited by V8NRG on Thursday 21st October 21:52
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


