Discussion
I removed the silver insulation from the smooth bore elbow,it does look better but it gets very hot.Does that not worry you,hot air is not a good idea.Im going to try again and do a better job
I like the silver sleeve on the induction ,where did you get that from.

I like the silver sleeve on the induction ,where did you get that from.
Edited by SILICONE KID on Friday 29th October 17:20
Silver insulation is from Wicks! Its basically a 5" corrogated aluminium/tin foil duct (I think plumbers use it for air ducting stuff) I just sleeved it straight on - be careful its quite fragile.
I'm pretty sure I only paid a few pounds for it.....aside the stuff selling in the specialists it was a steel.
I'm pretty sure I only paid a few pounds for it.....aside the stuff selling in the specialists it was a steel.
What about that smooth bore elbow,its red hot..Does it not make a difference..
By the way im a Gas Safe heating engineer.Been in the trade since 1984 trained as a commercial pipe fitter and never touched plastic ducting..
My company is DC PLUMBING HEATING & GAS SERVICES.!

By the way im a Gas Safe heating engineer.Been in the trade since 1984 trained as a commercial pipe fitter and never touched plastic ducting..
My company is DC PLUMBING HEATING & GAS SERVICES.!Edited by SILICONE KID on Friday 29th October 22:33
SILICONE KID said:
Yes Corgi before but Gas Safe could do it cheaper.
Im just messingI think heres the stuff he's talking about from wickes (looks like im going there tomorrow my self)
http://www.wickes.co.uk/Aluminium-Ducting/invt/713...
Before you guys get all technical about U bends, elbow joints, not to mention the rear connections (careful there)
I was under the impression that the induction pipe need to be smooth to help the air flow and not to tumble, so using the Plumbers pipe will this not increase the induction problems
?
I was under the impression that the induction pipe need to be smooth to help the air flow and not to tumble, so using the Plumbers pipe will this not increase the induction problems
?Mr MoJo said:
pbaker43, I think the ducting is slipped over the smooth bore pipe ??
It actually looks very neat, does is slip over easily, ie is it the correct diameter to cover the smooth bore pipe or does it need cutting ?
May be a trip to Wickes on the cards !!
No cutting and just slips straight over - be careful when putting the AFM back on - mods dont get much easier or cheaper than this. I had thought that I should wrap the indiction pipe before fitting the duct over the top....but I couldnt be arsed. There is a good air gap (bet duct and intake pipe)that should add some insulating value.It actually looks very neat, does is slip over easily, ie is it the correct diameter to cover the smooth bore pipe or does it need cutting ?
May be a trip to Wickes on the cards !!
Alexdaredevilz said:
SILICONE KID said:
Yes Corgi before but Gas Safe could do it cheaper.
Im just messingI think heres the stuff he's talking about from wickes (looks like im going there tomorrow my self)
http://www.wickes.co.uk/Aluminium-Ducting/invt/713...

Gassing Station | Chimaera | Top of Page | What's New | My Stuff









feel a prat for asking 