Pefect drive yesterday, now it won't start.
Pefect drive yesterday, now it won't start.
Author
Discussion

Green is good

Original Poster:

80 posts

208 months

Sunday 7th November 2010
quotequote all
Took out the Chim yesterday for a relaxed drive through the stunning Borders countryside in the winter sun and it was brilliant, roof off, even the other half enjoyed it. It ran so well all day. Weather the same today so I said lets go again for a last drive before the winter layup. But, it won't start now.

Turned on the ignition, fuel pump buzzed as usual but normally it stops after a few seconds, this time it kept buzzing and there was a curious taping sound from under the bonnet. Switched off and back on again, this time the pump stoppped buzzing after a few secs and no strange noise but it will not start. Tries to, fires a bit but will not go at all. What a bummer. No smell of petrol or anything like that, can't see anything unusal/fallen off/melted etc under the bonnet. First thought is the fuel pump has given up, but it still makes a noise. Did notice yeserday that on at least one occasion after the engine was started, the fuel pump could be heard still buzzing, then it gradually stopped making a noise. Any ideas? Someone will have had the same fault I'm sure!!!

First real problem in nearly two years so not too bad I suppose.

Any ideas gratefully received.

blitzracing

6,422 posts

251 months

Sunday 7th November 2010
quotequote all
Its the CPU in the ECU unit failing to start (ie boot up). This is proved by the fact the pump keeps running, when the ECU program stops this after a few seconds normally, and the injectors (the ticking sound) fire erratically when this happens. Dont leave it running like this, it fills up the inlet ports with fuel! Its most likely just be the fuel map Eprom chip thats failed, or maybe just needs reseating, but its worth disconnecting the ECU for 30 seconds for a reset before you pull it to bits.

m996tt

407 posts

242 months

Sunday 7th November 2010
quotequote all
You have checked to see if you have fuel!
just a thought.

Green is good

Original Poster:

80 posts

208 months

Sunday 7th November 2010
quotequote all
Thanks for the advice guys, always so good on here. Not really sure what you are saying to be honest Blitzracing but if I am reading you correctly, you think disconnecting the ecu may perhaps work, is this the box in the footwell over the battery? I'm not a technically minded person really. Sorry to sound so dumb but I don't want to F it up any more than it is. And the Eprom chip, is that easily available, there is a LR dealer near where I live, could I get one there as I'm sure I recall someone saying the engines and gizmos that run it are Range Rover bits.

m996tt, I haven't looked to see if fuel is getting to the engine but there is no smell of fuel even after turning it over and over.

Barkychoc

7,848 posts

235 months

Sunday 7th November 2010
quotequote all
Clicking initially could have been stepper motor resetting?
Mine does it a bit of a quickfire clicking noise then it stops.

Doesn't explain pump running though frown

blitzracing

6,422 posts

251 months

Sunday 7th November 2010
quotequote all
The ECU unit has a pluggable controlling chip inside it that does 2 things. Firstly it has the operating system the internal microprocessor needs to actually run just like a PC needs windows to boot up, and secondly, once it has booted up, the chip also contains all the data needed to correctly fuel the engine (the fuel map that gets change when you "chip" and engine). If the microprocessor fails to boot, you get exactly the symptoms you describe, and this can happen if this all important chip gets corrupted or is not seated in its socket correctly. A with most computers, its worth a power off and on reset as a first thing to try, and you can do this by locating the ECU, (Big black box in the passenger foot well above the battery) and unlatching the big plug and loom on the side. (It sort of hinges off once you release the locking tab) This must be done with the ignition OFF, but even so there is still power in the ECU, which must be interrupted to do the reset. If this fails the ECU needs to be removed, and opened up with a star driver, and the large pluggable Eprom chip will bee seen on the PCB inside. In this example its marked G33xxxx, but on the TVR its marked with the engine size and if it the car has catalyst or not, like "4.5 cat". You can try gently lifting the chip in its socket a bit and re seating it to ensure the corrections are good. If this fails the chip may be faulty, but they are TVR specific, not Land Rover, but I dont mind lending you a chip to test if you want. Its also possible the ECU itself has failed, but you need to try these steps first, but if your local Land Rover dealer has a second hand ECU they can plug in all well and good, the car will run with a non TVR chip, but its not a permanent fix . Just to double check my diagnosis before we go to far, get someone to listen to the injectors that are in the top on the engine when you turn on the ignition (dont try and start). The fault will be heard as an erratic light ticking from this area and the fuel pump will run continuously.




Edited by blitzracing on Sunday 7th November 20:11

Green is good

Original Poster:

80 posts

208 months

Sunday 7th November 2010
quotequote all
Thanks very much for the very helpful advice, I will give it a go an see what happens. Will probably be a couple of days before i can get to it now though. Many thanks.

Good Soil (Pete)

543 posts

292 months

Monday 8th November 2010
quotequote all
Might be worth checking the fuel pump relay has not failed....

SMB

1,523 posts

297 months

Monday 8th November 2010
quotequote all
blitzracing said:
The ECU unit has a pluggable controlling chip inside it that does 2 things. Firstly it has the operating system the internal microprocessor needs to actually run just like a PC needs windows to boot up, and secondly, once it has booted up, the chip also contains all the data needed to correctly fuel the engine (the fuel map that gets change when you "chip" and engine). If the microprocessor fails to boot, you get exactly the symptoms you describe, and this can happen if this all important chip gets corrupted or is not seated in its socket correctly. A with most computers, its worth a power off and on reset as a first thing to try, and you can do this by locating the ECU, (Big black box in the passenger foot well above the battery) and unlatching the big plug and loom on the side. (It sort of hinges off once you release the locking tab) This must be done with the ignition OFF, but even so there is still power in the ECU, which must be interrupted to do the reset. If this fails the ECU needs to be removed, and opened up with a star driver, and the large pluggable Eprom chip will bee seen on the PCB inside. In this example its marked G33xxxx, but on the TVR its marked with the engine size and if it the car has catalyst or not, like "4.5 cat". You can try gently lifting the chip in its socket a bit and re seating it to ensure the corrections are good. If this fails the chip may be faulty, but they are TVR specific, not Land Rover, but I dont mind lending you a chip to test if you want. Its also possible the ECU itself has failed, but you need to try these steps first, but if your local Land Rover dealer has a second hand ECU they can plug in all well and good, the car will run with a non TVR chip, but its not a permanent fix . Just to double check my diagnosis before we go to far, get someone to listen to the injectors that are in the top on the engine when you turn on the ignition (dont try and start). The fault will be heard as an erratic light ticking from this area and the fuel pump will run continuously.




Edited by blitzracing on Sunday 7th November 20:11
I had this very fault a numbe rof years back, can be intermittent, one day works fine, the next not. It can fill the cylinders with fuel and cause hydraulic lock eventually. If it's done it for some time now, I woul dsuggets considering an oil change too, in case it's contaminated with fuel.

Green is good

Original Poster:

80 posts

208 months

Monday 8th November 2010
quotequote all
SMB said:
blitzracing said:
The ECU unit has a pluggable controlling chip inside it that does 2 things. Firstly it has the operating system the internal microprocessor needs to actually run just like a PC needs windows to boot up, and secondly, once it has booted up, the chip also contains all the data needed to correctly fuel the engine (the fuel map that gets change when you "chip" and engine). If the microprocessor fails to boot, you get exactly the symptoms you describe, and this can happen if this all important chip gets corrupted or is not seated in its socket correctly. A with most computers, its worth a power off and on reset as a first thing to try, and you can do this by locating the ECU, (Big black box in the passenger foot well above the battery) and unlatching the big plug and loom on the side. (It sort of hinges off once you release the locking tab) This must be done with the ignition OFF, but even so there is still power in the ECU, which must be interrupted to do the reset. If this fails the ECU needs to be removed, and opened up with a star driver, and the large pluggable Eprom chip will bee seen on the PCB inside. In this example its marked G33xxxx, but on the TVR its marked with the engine size and if it the car has catalyst or not, like "4.5 cat". You can try gently lifting the chip in its socket a bit and re seating it to ensure the corrections are good. If this fails the chip may be faulty, but they are TVR specific, not Land Rover, but I dont mind lending you a chip to test if you want. Its also possible the ECU itself has failed, but you need to try these steps first, but if your local Land Rover dealer has a second hand ECU they can plug in all well and good, the car will run with a non TVR chip, but its not a permanent fix . Just to double check my diagnosis before we go to far, get someone to listen to the injectors that are in the top on the engine when you turn on the ignition (dont try and start). The fault will be heard as an erratic light ticking from this area and the fuel pump will run continuously.




Edited by blitzracing on Sunday 7th November 20:11
I had this very fault a numbe rof years back, can be intermittent, one day works fine, the next not. It can fill the cylinders with fuel and cause hydraulic lock eventually. If it's done it for some time now, I woul dsuggets considering an oil change too, in case it's contaminated with fuel.
This is the first time this has happened. Very annoying as the drive the day before was so good, it ran like a dream, very smooth and powerful. Drive home, park it up, next day it won't go! That's TVR ownership I suppose. I will take your advice though. I had thought that these things were going to pass me by for some reason. Back down to earth now. Perhaps it didn't want to get put away for the winter and is protesting. I want to use it next weekend now though. Thanks for the reply.

Green is good

Original Poster:

80 posts

208 months

Tuesday 9th November 2010
quotequote all
Green is good said:
SMB said:
blitzracing said:
The ECU unit has a pluggable controlling chip inside it that does 2 things. Firstly it has the operating system the internal microprocessor needs to actually run just like a PC needs windows to boot up, and secondly, once it has booted up, the chip also contains all the data needed to correctly fuel the engine (the fuel map that gets change when you "chip" and engine). If the microprocessor fails to boot, you get exactly the symptoms you describe, and this can happen if this all important chip gets corrupted or is not seated in its socket correctly. A with most computers, its worth a power off and on reset as a first thing to try, and you can do this by locating the ECU, (Big black box in the passenger foot well above the battery) and unlatching the big plug and loom on the side. (It sort of hinges off once you release the locking tab) This must be done with the ignition OFF, but even so there is still power in the ECU, which must be interrupted to do the reset. If this fails the ECU needs to be removed, and opened up with a star driver, and the large pluggable Eprom chip will bee seen on the PCB inside. In this example its marked G33xxxx, but on the TVR its marked with the engine size and if it the car has catalyst or not, like "4.5 cat". You can try gently lifting the chip in its socket a bit and re seating it to ensure the corrections are good. If this fails the chip may be faulty, but they are TVR specific, not Land Rover, but I dont mind lending you a chip to test if you want. Its also possible the ECU itself has failed, but you need to try these steps first, but if your local Land Rover dealer has a second hand ECU they can plug in all well and good, the car will run with a non TVR chip, but its not a permanent fix . Just to double check my diagnosis before we go to far, get someone to listen to the injectors that are in the top on the engine when you turn on the ignition (dont try and start). The fault will be heard as an erratic light ticking from this area and the fuel pump will run continuously.




Edited by blitzracing on Sunday 7th November 20:11
I had this very fault a numbe rof years back, can be intermittent, one day works fine, the next not. It can fill the cylinders with fuel and cause hydraulic lock eventually. If it's done it for some time now, I woul dsuggets considering an oil change too, in case it's contaminated with fuel.
This is the first time this has happened. Very annoying as the drive the day before was so good, it ran like a dream, very smooth and powerful. Drive home, park it up, next day it won't go! That's TVR ownership I suppose. I will take your advice though. I had thought that these things were going to pass me by for some reason. Back down to earth now. Perhaps it didn't want to get put away for the winter and is protesting. I want to use it next weekend now though. Thanks for the reply.
Well, I did exactly as you said Blitzracing, unplugged the ecu, plugged it back again after a few minutes, turned the key and away she went, so you were 100% right. Thanks so much for your very helpful advice, you saved me hours of messing about.

Do you think I should just leave it now, or take out the ecu and wiggle the Eprom chip a bit as you suggested or just leave well alone now?

I'm so chuffed with this result, TVRs, don't you just love em!

blitzracing

6,422 posts

251 months

Tuesday 9th November 2010
quotequote all
Well something caused the ECU to "hang" in the first place, so I would just move the chip in its socket just a tad, just to remove any oxidation that may have occurred between the chip leg and socket. If it does it again, least you know it wont be chip seating.

roysum

961 posts

220 months

Tuesday 9th November 2010
quotequote all
He's good that blitzracing man !!