Fitting 18" Wheels
Fitting 18" Wheels
Author
Discussion

ph1l5

Original Poster:

5,027 posts

233 months

Monday 8th November 2010
quotequote all
Will 18" Wheels go onto a chim whithout any major dramas ?

Cider Andy

1,889 posts

256 months

Monday 8th November 2010
quotequote all
They should do, but you'd need a very low profile tyre to keep the same rolling radius. You might also find the tyre fouls the bodywork inside the wheelarch. And becasue of needing a lower profile tyre, the ride might suffer and tramlining might be increased.

bobfather

11,197 posts

286 months

Monday 8th November 2010
quotequote all
There's much discussion on this if you read this forum. The biggest concern is that 18" on the front causes a few handling issues because the tyre wall has to be very small. First is rim bump where the alloy rim hits the inside of the tyre. People try to overcome this by increasing the tyre pressure but there's questionable logic in that. The lateral movement of your front tyres eliminates tram lining, smaller sidewall = lest lateral movement and therefore more tram lining. If the tyre has no wall to tuck in under heavy cornering it will tend to skip on the road causing jump understeer (bump steer).

People here often suggest 17" is the sensible biggest option for the front, 18" is apparently OK on the rears. I have used 18" spiders all round, fitted them when I did my 5 stud conversion, but I personally prefer the feel of the 16" spiders. This may be because I like undulating country roads where rim bump and bump steer would become a problem


Edited by bobfather on Monday 8th November 16:47

HiAsAKite

2,559 posts

278 months

Monday 8th November 2010
quotequote all
I have 17" fronts, 18" back, running T1-Rs all round without any major drama's, as others have said you need to get the tyre pressures right though.

Key thing is ensuring you get the right offsets, and setting the profile to keep the overall wheel diameter as close as possible to original

Edited by HiAsAKite on Monday 8th November 18:36