Waxoyl - it stinks!
Waxoyl - it stinks!
Author
Discussion

Lighterfuel

Original Poster:

71 posts

195 months

Tuesday 9th November 2010
quotequote all
Stuck 'Marjory' (4.0 HC) into my friendly local garage for a good old waxoyl in preparation for winter. Was tempted to do it myself but glad i didn't coz it's horrible stuff! Cockpit is a bit smelly at the moment, but sure it will dissipate over time. My local garage did a great job by the way (AJ Ross in Aberdeen where I've taken all my cars since i was a nipper) and they also commented on the chassis being in exceptionally good condition.....makes for a very happy Phil!

Will monitor the waxoyl over the winter to see how it performs as i've herd good and bad stories.

blueg33

46,949 posts

255 months

Tuesday 9th November 2010
quotequote all
Lighterfuel said:
Stuck 'Marjory' (4.0 HC) into my friendly local garage for a good old waxoyl in preparation for winter. Was tempted to do it myself but glad i didn't coz it's horrible stuff! Cockpit is a bit smelly at the moment, but sure it will dissipate over time. My local garage did a great job by the way (AJ Ross in Aberdeen where I've taken all my cars since i was a nipper) and they also commented on the chassis being in exceptionally good condition.....makes for a very happy Phil!

Will monitor the waxoyl over the winter to see how it performs as i've herd good and bad stories.
It is truely horrible stuff to apply at home! The spray lance makes it go all over the place and the on/off control is a bit hit and miss. I managed to waxoyl a fair portion of my drive and the inside of one of my rigger boots (even though I was wearing it at the time)

More Steam

698 posts

221 months

Tuesday 9th November 2010
quotequote all
As the last person to "squirt" Marjory getmecoat, I have to agree. It gets everywhere.

blackchim

91 posts

195 months

Tuesday 9th November 2010
quotequote all
Totally agree, got the whole package from halfrauds and it goes everywhere. Lance has little control in that it keeps squirting after you swicth off. Now use Dynax with wand which has a brass multi hole head.This gets on top of the outriggers/hard to access areas. The appearance is better too!

amazon

3,704 posts

242 months

Tuesday 9th November 2010
quotequote all
On good recommendation, I used a Hammerite product called 'Schulz'. I used it on the Cerbera and a couple of years later it really only required a a bit of work to bring it up to scratch again. Very impressed smile.

(You need a compresser for it though, but I managed not to get completely covered in it tongue out)

speedtwelve

3,547 posts

304 months

Tuesday 9th November 2010
quotequote all
It doesn't taste very good either.

SILICONE KID

14,997 posts

262 months

Tuesday 9th November 2010
quotequote all
I only use waxoyl above the outriggers and triangular plates,can`t understand why it needs to be sprayed every where causing a complete mess attracting even more dirt.Is it not better to spend a bit longer painting the chassis ,outriggers and wishbones.

Edited by SILICONE KID on Wednesday 10th November 10:21

roysum

961 posts

220 months

Tuesday 9th November 2010
quotequote all
SILICONE KID said:
I only use waxoyl above the outriggers and triangular plates,can`t understand why it needs to be sprayed every where causing a complete mess attacting even more dirt.Is it not better to spend a bit longer painting the chassis ,outriggers and wishbones.
I agree with you there Daz, for tops of the tubes I reckon the Waxoyl aerosol is the best bet.

SILICONE KID

14,997 posts

262 months

Tuesday 9th November 2010
quotequote all
I am now rubbing down the brush finish Epoxy mastic .i have a small cheap compressor and just purchased a cheap spray gun.It keeps you busy better than watching the
rubbish on the tellylaughI
like this stuff
comes with thinners.Im going to attack the top of the out riggers with a very large syringe and a length of thin tubing..Its something to do..Ive seen how some of the garages apply waxoyl ,they spray it all over the c
censoredp causing more problems.
http://cgi.ebay.co.uk/RUSTBUSTER-EPOXY-MASTIC-5m2-...



Edited by SILICONE KID on Wednesday 10th November 00:02

Lighterfuel

Original Poster:

71 posts

195 months

Wednesday 10th November 2010
quotequote all
speedtwelve said:
It doesn't taste very good either.
Was not really thinking of giving Marjory's undercarriage a lick lick.......I'm sure there are websites for that sort of behavior. hehe

More Steam has looked after her with waxoyl and it appears to have done the job nicely so far. May be persuaded to to try something else in the future tho.

Mark_S_24

405 posts

207 months

Wednesday 10th November 2010
quotequote all
Lighterfuel said:
speedtwelve said:
It doesn't taste very good either.
Was not really thinking of giving Marjory's undercarriage a lick lick.......I'm sure there are websites for that sort of behavior. hehe

More Steam has looked after her with waxoyl and it appears to have done the job nicely so far. May be persuaded to to try something else in the future tho.
Perhaps he thought Wax Oyl was Olive Oyl's sister & thought he was in there? :-)

Mark