Discussion
they are sony xs-F1736SE's 200W peak power rated. I also have slighthly smaller ones in the doors which gave a decent sound on their own, but these blow them away.
Just mark template outline centred on vent hole, trim back carpet wth stanley knife or similar (cuts easily), then I just drilled multiple holes through the fibreglass panel following same template and the speakers popped in!
Just mark template outline centred on vent hole, trim back carpet wth stanley knife or similar (cuts easily), then I just drilled multiple holes through the fibreglass panel following same template and the speakers popped in!
Just in case anyone else is planning to do this; I ended up using the Sony XS-F1326SE 5 1/4" version. These just drop into the existing holes with no modifications or cutting needed. I did use shorter screws than those supplied as I was a bit worried about touching the existing wiring.
Probably not quite as good as the 17cm version, but fine for me and a definate improvement! £25 from Amazon.
The supplied wires are just the right length to reach the existing connector in the passenger side hatch too. I did the whole job in less than an hour.
Probably not quite as good as the 17cm version, but fine for me and a definate improvement! £25 from Amazon.
The supplied wires are just the right length to reach the existing connector in the passenger side hatch too. I did the whole job in less than an hour.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


