Seat Leon Cupra turbo boost issues
Seat Leon Cupra turbo boost issues
Author
Discussion

dazjstuart

Original Poster:

32 posts

178 months

Friday 17th February 2012
quotequote all
Hi Everyone,

I think I have developed an issue with the turbo on my 2003 Seat Leon Cupra (VAG 1.8T 20V engine). It seems to loose some boost at higher revs but doesnt always do it. Difficult to describe but its like you put the foot down it pulls like a freight train up untill around 4-4500 revs then seems to hit a wall, however if you take your foot off then put it back down it surges forwards again and is good for another few hundred revs before doing the same.

It only seems to do this under hard acceleration and is not noticeable when driving normally but its a pain in the ass when you drop a couple of gears and floor it for an overtake. It also dosent seem to be as bad when the engine is cold (although I dont really like exploring the upper rev ranges when its cold so havent tried properly).

I dont think its the turbine itself as it still pulls hard for a start?

Does anyone have any experience of this problem or have any ideas? Bear in mind although I claim to know a reasonable amount about mechanics but am by no means an expert!

Any help appreciated guys!

Cheers

Cupramax

11,007 posts

283 months

Friday 17th February 2012
quotequote all
I'd start by replacing the N75 valve and then diverter valve with something like a Forge below. Do one at a time and see if it sorts it.

http://www.forgemotorsport.co.uk/content.asp?inc=p...

MonkeyHanger

9,267 posts

273 months

Friday 17th February 2012
quotequote all
Find someone with a fault code reader. smile

Dr G

16,011 posts

273 months

Saturday 18th February 2012
quotequote all
Cupramax is on the money, they're certainly the two most common culprits.

How many miles has the car done? The standard diverter is often worn out by 50k.

dazjstuart

Original Poster:

32 posts

178 months

Saturday 18th February 2012
quotequote all
Thanks for the ideas guys, I had read elsewhere about the diverter valve / N75 having issues. Dr G, its done around 60k so your probably right. Any idea how much a standard diverter valve is?

Dr G

16,011 posts

273 months

Saturday 18th February 2012
quotequote all
45 quid I think.

BBS-LM

3,978 posts

255 months

Saturday 18th February 2012
quotequote all
I had the same problem as you, First thing to do is get a Vag Com Scan, and if no error's come back change the N75 Valve. I had a faulty valve and did a scan with VAG COM and it did not pick up on the faulty valve because it was intermittent.

keith west

8 posts

166 months

Sunday 27th January 2013
quotequote all
Hello I have a cupra 1,8 turbo and I think I have a boost prob. When I'm in 5th or 6th gear cruising at around 60 70 mph I will accelerate and it doesent pull at all it just revs like I have dipped the clutch in very frustrating does anyone know wot the prob is ? .And will it damage the turbo ?. Thanks

Dr G

16,011 posts

273 months

Sunday 27th January 2013
quotequote all
Sounds more like your clutch is slipping.

shakey85

2 posts

152 months

Saturday 15th March 2014
quotequote all
Hi everybody I own a 02 1.8 20vt seat leon
And I have a turbo surge I have replaced my dump
Valve from a forge splitter valve to a 007p but still have a surge
I have been told it's a pipe under the inlet manifold anybody have a link for this
Please sorry for the long post

Cheers