What tool/s do I need to remove EGR Valve?
Discussion
Need a little help, as I want to clean my EGR Valve. I took out the 2 big screws on the right side, just need to remove the little screws. I had a look inside the EGR, and the oil seem's to be very dry. Is this normal?
Pics below....

[url=http://www.flickr.com/photos/50322684@N02/10888948746/

[url=http://www.flickr.com/photos/50322684@N02/10888944456/]
Pics below....

[url=http://www.flickr.com/photos/50322684@N02/10888948746/

[url=http://www.flickr.com/photos/50322684@N02/10888944456/]
If the allen key is pointing at what you think is the EGR valve then you're a bit lost. That's the ASV (anti stutter valve).
The EGR is the one above with the metal pipe going into it.
Should be dry but can have a very small bit of juice in it. If it's very wet then there's other issues.
The EGR is the one above with the metal pipe going into it.
Should be dry but can have a very small bit of juice in it. If it's very wet then there's other issues.
EGR valve and ASV should come out together, 5mm and 6mm allen keys IIRC. They then separate once off the car. There will be a gasket/O ring between the two and another between EGR and inlet manifold. I'd replace the gaskets as best practice.
Is the EGR vacuum controlled or electronically? Either way don't put the whole thing into anything too solvent. If vacuum controlled it could harm the diaphragm, if electronic I just wouldnt want to soak it! So try and stand it in a bucket so the mechanicals are out of the liquid.
Is the EGR vacuum controlled or electronically? Either way don't put the whole thing into anything too solvent. If vacuum controlled it could harm the diaphragm, if electronic I just wouldnt want to soak it! So try and stand it in a bucket so the mechanicals are out of the liquid.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


