B4 16v Audi Coupe - longitudinal engine layout?
B4 16v Audi Coupe - longitudinal engine layout?
Author
Discussion

ReaderScars

Original Poster:

6,087 posts

207 months

Sunday 19th January 2014
quotequote all
Does the B4 16v coupe have a longitudinal engine layout - or does this denote some sort of quattro variant or project, maybe?

I've seen an under the bonnet pic and it's definitely longitudinal and the inlet manifold is marked DOHC - was this the norm for a 94 2.0 front wheel drive coupe?

DocArbathnot

29,115 posts

214 months

Sunday 19th January 2014
quotequote all
Yup the norm, I don't think they made a 2.0q. As far as I know all Audis have longitudal engines until the A3 and the use of a shared floor pan with the golf.

FWIW In the Audis I always found the 16v harsh and prefer the 8v, albeit lower power, it seems more tractable. The 2.0 units were shared with VW just different transmissions.

The earlier (pre facelift) 5 cyl engines were nice some were quattro. The later cars were also available as V6's 2.6 fwd or 2.8q.

ReaderScars

Original Poster:

6,087 posts

207 months

Sunday 19th January 2014
quotequote all
Ah, thanks for the clarification - answers a few questions, I thought perhaps it was some project car or other with a two litre lump dropped into a quattro based car. Although I have read about the weight distribution drawbacks of this layout in some older audis, just surprised to see a longitudinal engine in FWD.

DocArbathnot

29,115 posts

214 months

Sunday 19th January 2014
quotequote all
It's the way Audi do it. I think it's to give you equal length driveshafts which helps reduce torque steer. (I'm led to belive)

I think this layout also helped (at the time) with the (pre airbag) procon ten system.

FWIW Audi still use this layout.


istoo

2,365 posts

233 months

Sunday 19th January 2014
quotequote all
Much more to do with the quattro drivetrain setup, or rather quattro to FWD and production.



All the engines were inline, you can imagine how much room there was with the inline 5 in there!
if you like the shape i would suggest a 5 pot 20v, the (2.3 7A) is the best of the line up. The 5 cylinders were in the B3 chassis, the V6s (2.8 AAH & 2.6 ABC) replaced 5 pots and appeared in the B4s. The B4 coupe has aged well imho, handsome coupe. Audi did make a limited number of B4 16v quattro's, fairly sure they were just saloons for homiglination purposes.

had 10 years of owning variants of the above, have a real soft spot for them. Regret not buying my mates RS2 six months ago.



Edited by istoo on Sunday 19th January 17:53

Yertis

19,745 posts

297 months

Sunday 19th January 2014
quotequote all
I've been batting around in my daughters B4 8V recently (non-quattro of course) and I have to say I felt it handled far more nicely than the B3 that my wife used to own that was fitted with the 5-cylinder engine. Although it sounded much nicer, it really did oversteer like a bh.

Big fan of B3/B4 though, beautifully built cars.

ReaderScars

Original Poster:

6,087 posts

207 months

Sunday 19th January 2014
quotequote all
The insights you've all provided are appreciated, thank you.

As attractive as the 5/6 cylinder engined cars sound and perform in comparison, the relative economy of the 2.0 is the deciding factor.

In fact, although I've had a soft spot for B3/4 coupes, my head is saying 52/53 Toyota Celica instead of 94 Audi.

Having said that I'm awaiting the results of an MOT test tomorrow to see whether a B4 coupe I know of is sound - if so it could well be my runabout.

I've read that the rear subframe mounts are a point of cencern as well as the windscreen corner milking.

Would be good to hear about any other issues which could throw up a big bill. I can undertake the usual service items no problem, so stripping/refurbing rear calipers I'm happy to tackle.

What would you look for?

Yertis

19,745 posts

297 months

Monday 20th January 2014
quotequote all
Cabin heater matrix. Common fault. Bit of a pain to fix properly as involves pulling out the entire dash panel etc.

istoo

2,365 posts

233 months

Monday 20th January 2014
quotequote all
Yertis said:
Cabin heater matrix. Common fault. Bit of a pain to fix properly as involves pulling out the entire dash panel etc.
I knew you would bite!

usual things of woe are, which are minor to be fair;

-Brake Accumulator, look out for the (!) on the autocheck.
-rusty arches, there is a nice lip which catches winter muck beautifully
-leaky boot, the seals around the rear light slam panel tend to fail. you will get water in the boot if its the case.
-Headlights like candles. Osram nightbreakers werent around then but i am sure they would improve matters now.
-Fuel lines (under the drivers side) are made of mild steel, often replaced for plastic/copper.
-Milking on the windscreen is a visible thing, had on about half my old ausis but none have ever leaked or caused further issue. The windscreen is bonded thus is be careful if you decide to change it make sure you get a good fitter who doesnt bodge it.
-front suspension tends to get a battering, low profile wheel/tyre changes dont help either. So be cogniscent of that.

Mike Dewar has a nice write up on his site, a few S2 specific things but a lot that relate to the coupe in general http://www.s2-audi.co.uk/tech_articles/buyers.htm

the 16v'ers do go well. As a run around, its a nice choice!

But they are well built, still a good looking car imho.

Oh the velour seats are fecking horrid, hope for sport seats!


ReaderScars

Original Poster:

6,087 posts

207 months

Monday 20th January 2014
quotequote all
Yertis said:
Cabin heater matrix. Common fault. Bit of a pain to fix properly as involves pulling out the entire dash panel etc.
Okay, will bear it in mind thanks.

ReaderScars

Original Poster:

6,087 posts

207 months

Monday 20th January 2014
quotequote all
istoo said:
I knew you would bite!

usual things of woe are, which are minor to be fair;

-Brake Accumulator, look out for the (!) on the autocheck.
-rusty arches, there is a nice lip which catches winter muck beautifully
-leaky boot, the seals around the rear light slam panel tend to fail. you will get water in the boot if its the case.
-Headlights like candles. Osram nightbreakers werent around then but i am sure they would improve matters now.
-Fuel lines (under the drivers side) are made of mild steel, often replaced for plastic/copper.
-Milking on the windscreen is a visible thing, had on about half my old ausis but none have ever leaked or caused further issue. The windscreen is bonded thus is be careful if you decide to change it make sure you get a good fitter who doesnt bodge it.
-front suspension tends to get a battering, low profile wheel/tyre changes dont help either. So be cogniscent of that.

Mike Dewar has a nice write up on his site, a few S2 specific things but a lot that relate to the coupe in general http://www.s2-audi.co.uk/tech_articles/buyers.htm

the 16v'ers do go well. As a run around, its a nice choice!

But they are well built, still a good looking car imho.

Oh the velour seats are fecking horrid, hope for sport seats!
Thanks for the list and link - got a few further questions if you don't mind...!

The front suspension might be affected as it does have low profiles fitted in comparison to the OM alloys - what specifically am I looking for? Tired shocks or issues with top mounts/drop links...? Having said that it went through it's MOT today with just a bulb needing replacement, no advisories apparently.

Is the brake accumulator known as 'the bomb'?

Arches seem OK from pics, will take a close look at the windscreen and fuel lines, although I assume any corrosion/issues would've been caught...Leaks around the lights I can sort out.

What is the autocheck - a startup diagnostic? - will look for the !. Will read through the linked article.

Thanks again.

ReaderScars

Original Poster:

6,087 posts

207 months

Monday 20th January 2014
quotequote all
Just to add, that article is exactly what I'm looking for, ta!

jith

2,752 posts

246 months

Tuesday 21st January 2014
quotequote all
Yertis said:
Cabin heater matrix. Common fault. Bit of a pain to fix properly as involves pulling out the entire dash panel etc.
You mean like this?







A big smile for warm toes!



The Final Edition Cabriolet is the worst one to do because it has airbags and different stiffening behind the dash, but a job worth while despite the effort.

Just about to tackle a 90 Quattro 20 valve. It is one of the few weaknesses with the 80/90 models, although they are usually 15+years old before they fail!

By the way, you need access to Vagcom to reset the airbag system if you are doing a later one.

J

decadent

2,572 posts

206 months

Tuesday 21st January 2014
quotequote all
What’s the advantage of the FWD longitudinal layout? Weight balance/equal length drive shafts?